Cisco IPS 4200 Series Sensors

Document ID: 15252

Contents

Introduction
Prerequisites
      Requirements
      Components Used
      Conventions
Required Cable
Null-Modem Cable Pinout
How to Log in Using the COM Port
NetPro Discussion Forums - Featured Conversations
Related Information

Introduction

Some tasks require you to log into a Cisco Secure Intrusion Detection System (IDS)/ Intrusion Prevention System (IPS) Sensor directly. For example, initializing a Cisco Secure IDS/IPS Sensor requires you to log into the CLI and run the setup command. Other tasks that require you to log into a Cisco Secure IDS Sensor include changing the Cisco Secure IDS/IPS Sensor's IP address, subnet mask and/or default gateway, and troubleshooting certain errors.

You can log into the Cisco Secure IDS/IPS Sensor using one of these methods.

• Through the system console (a directly-connected keyboard and monitor).

• Telnet into the Cisco Secure IDS/IPS Sensor.

• Browse to the Cisco Secure IDS/IPS Sensor using https.

• Connect a PC to the COM port on the Cisco Secure IDS/IPS Sensor and use a communications package.

This document describes how to log into the Cisco Secure IDS/IPS Sensor using the last method.

Prerequisites

Requirements

There are no specific requirements for this document.

Components Used

The information in this document is based on Cisco Secure IDS version 4.x and IPS 5.x and later.

Note: The same cable as described in this document works with all sensor versions back to 2.2.0.x.

The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.

Conventions

For more information on document conventions, refer to the Cisco Technical Tips Conventions.

Required Cable

You need a DB-9-to-DB-9 null-modem cable to connect a PC to the COM port on the Cisco Secure IDS/IPS Sensor. This cable is sold as a serial LapLink or File Transfer Cable. Be careful with null-modem adapters/connectors because they do not always work for this application. The null-modem cable pinout is provided in this document if you want to build your own. You need DB-9 female connectors at each end.

Null-Modem Cable Pinout

How to Log in Using the COM Port

Complete these steps.

1. Using the null-modem cable, connect the appropriate COM port on the PC to the COM 1 port on the Cisco Secure IDS Sensor.

   The COM 1 port location on the different Cisco Secure IDS Sensor models are shown here.

   • 4210

     

   • 4215

     The 4215 Sensor has an RJ45 console port connector. Use the RJ45 console cable along with the DB-9 or DB-25 adaptor contained in the accessory kit to establish a console connection.

   • 4220/4230

     

   • 4235/4250

     

2. Once the PC and Cisco Secure IDS Sensor are connected, start your communications software on the PC. Configure the COM port settings in the communications software according to this table.

   Parameters	Settings
   Bits per second	9600
   Data bits	8
   Parity	None
   Stop bits	1
   Flow control	None

3. Connect the PC COM port to the Cisco Secure IDS Sensor using the communications software. If your call is successful, you see a <sensorname> login: prompt. If this is the first time you have logged in, use the default username/password of cisco/cisco (you are prompted to change the password).

NetPro Discussion Forums - Featured Conversations

Related Information

• Cisco IPS 4200 Series Sensors Support
• Documentation for Cisco Secure Intrusion Detection System
• Technical Support & Documentation - Cisco Systems