 Feedback
|
Table Of Contents
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
Obtaining Documentation, Support, and Security Guidelines
EU Directives 1999/5/EC & 93/42/ECC - Compliance Information for the Cisco Aironet 2600 series IEEE802.11 a/b/g/n Wireless LAN Products
August 2012
This document contains compliance information for the Cisco AIR-CAP2600 Series Access Points that is relevant to the European Union and other countries that have implemented the EU Directive 1999/5/EC and/or EU Directive 93/42/EC.
Contents
This document contains these sections:
•
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
•
Scope
The information in this document is applicable to the Cisco Aironet 2600 series wireless LAN products that currently include the following products:
The equipment operates in the 2400- to 2483.5-MHz frequency range, and depending on the product configuration, also in the 5150- to 5350-MHz and 5470- to 5725-MHz frequency range.
National regulations may require that operations be limited to portions of the frequency ranges identified above and/or at reduced power levels. See the National Restrictions for complete details.
Declaration of Conformity with Regard to the EU Directive 1999/5/EC (R&TTE Directive)
This declaration is only valid for configurations (combinations of software, firmware and hardware) provided and/or supported by Cisco Systems for use within the EU. The use of software or firmware not supported/provided by Cisco Systems may result that the equipment is no longer compliant with the regulatory requirements.
Note
The following standards were applied during the assessment of the product against the requirements of the Directive 1999/5/EC:
•
•
•
This device also conforms to the EMC requirements of the Medical Directive 93/42/EEC and as contained in EN 60601-1-2: 2001.
CE Marking
For the Cisco AIR-CAP2600 Series Access Points, the following CE mark and Class-2 identifier are affixed to the equipment and its packaging:
National Restrictions
Within the EU as well as within the majority of the other European Countries, the 2.4- and 5-GHz bands have been made available for the use of wireless LANs. Table 1 provides an overview of the regulatory requirements in general applicable for the 2.4- and 5-GHz bands.
Later in this section you will find an overview of countries in which additional restrictions or requirements or both are applicable.
The requirements for any country may evolve. Cisco recommends that you check with the local authorities for the latest status of their national regulations for both the 2.4- and 5-GHz wireless LANs.
Table 1 Overview of Regulatory Requirements for Wireless LANs
(EIRP)1 (mW)2400-2483.5
100
X
5150-5350
200
X
5470-5725
1000
X
1 Effective isotropic radiated power (EIRP).
The following sections identify countries having additional requirements or restrictions than those listed in Table 1.
Denmark
In Denmark, the band 5150 - 5350 MHz is also allowed for outdoor usage.
I Danmark må frekvensbåndet 5150 - 5350 også anvendes udendørs.
France
For 2.4 GHz, the output power is restricted to 10 mW EIRP when the product is used outdoors in the band 2454 - 2483.5 MHz. There are no restrictions when used indoors or in other parts of the 2.4 GHz band. Check http://www.arcep.fr/ for more details.
Pour la bande 2.4 GHz, la puissance est limitée à 10 mW en p.i.r.e. pour les équipements utilisés en extérieur dans la bande 2454 - 2483.5 MHz. Il n'y a pas de restrictions pour des utilisations en intérieur ou dans d'autres parties de la bande 2.4 GHz. Consultez http://www.arcep.fr/ pour de plus amples détails.
Italy
This product meets the National Radio Interface and the requirements specified in the National Frequency Allocation Table for Italy. Unless this wireless LAN product is operating within the boundaries of the owner's property, its use requires a "general authorization." Please check http://www.sviluppoeconomico.gov.it/ for more details.
Questo prodotto è conforme alla specifiche di Interfaccia Radio Nazionali e rispetta il Piano Nazionale di ripartizione delle frequenze in Italia. Se non viene installato all 'interno del proprio fondo, l'utilizzo di prodotti Wireless LAN richiede una "Autorizzazione Generale". Consultare http://www.sviluppoeconomico.gov.it/ per maggiori dettagli.
Latvia
The outdoor usage of the 2.4 GHz band requires an authorization from the Electronic Communications Office. Please check http://www.esd.lv for more details.
2.4 GHz frekvenèu joslas izmantoðanai ârpus telpâm nepiecieðama atïauja no Elektronisko sakaru direkcijas. Vairâk informâcijas: http://www.esd.lv.
Note
Antennas
The AIR-CAP2602I-E-K9 has integrated antennas which cannot be removed or are user accessible.
The AIR-CAP2602E-E-K9 is equipped with antenna connectors for the use of (external) dedicated antennas. See Table 2 for the applicable maximum conducted power settings for each of the antennas.
Table 2 Dedicated (external) Dual Band Antennas & Maximum Allowed Conducted Power Settings
AIR-ANT2524DB-R
2
4
17
17
17
Dual-resonant dipole
AIR-ANT2524DW-R
2
4
17
17
17
Dual-resonant dipole
AIR-ANT2524DG-R
2
4
17
17
17
Dual-resonant dipole
AIR-ANT2524V4C-R
2
4
17
17
17
Dual-resonant ceiling mount omni
AIR-ANT2544V4M-R
4
4
16
17
17
Dual-resonant omni
AIR-ANT2566P4W-R
6
6
14
17
17
Dual-resonant directional antenna
1 Outdoor operation is not allowed within 5150 - 5350 MHz.
Operating Frequency
The operating frequency in a Wireless LAN is determined by the access point. As such, it is important that the access point is correctly configured to meet the local regulations. See the "National Restrictions" section for the country specific operating frequency ranges.
Related Documentation
These documents provide information about the controllers and access points:
•
•
•
Note
Obtaining Documentation, Support, and Security Guidelines
Follow these steps to obtain any of the online documents mentioned in this document.
Step 1
http://www.cisco.com/en/US/products/hw/wireless/Step 2
Step 3
Step 4
http://www.cisco.com/en/US/docs/general/whatsnew/whatsnew.html
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S. and other countries. To view a list of Cisco trademarks, go to this URL: www.cisco.com/go/trademarks. Third-party trademarks mentioned are the property of their respective owners. The use of the word partner does not imply a partnership relationship between Cisco and any other company. (1110R)
Any Internet Protocol (IP) addresses used in this document are not intended to be actual addresses. Any examples, command display output, and figures included in the document are shown for illustrative purposes only. Any use of actual IP addresses in illustrative content is unintentional and coincidental.
© 2012 Cisco Systems, Inc. All rights reserved.
