Guest

Cisco BTS 10200 Softswitch

SIP Trunking for PBX

Table Of Contents

Cisco BTS 10200 Softswitch SIP Trunking for PBX Connection Feature Module


Cisco BTS 10200 Softswitch SIP Trunking for PBX Connection Feature Module


Revised: July 30, 2008

This document describes the Cisco BTS 10200 Softswitch Release 6.0 feature, SIP Trunking for PBX Connection, and lists the updates that will appear in the documentation set. (This feature module will be deleted as soon as the information has been folded into the main documentation set.)

The BTS 10200 communicates with the Cisco 2811 Integrated Services Router over SIP trunks. For the SIP-based PBX application, the Cisco 2811 acts as a time-division multiplexing (TDM) IP gateway. Additional details are as follows:

The Cisco 2811 IOS software tested by Cisco for interoperability is the IOS 12.4(11)XJ image.


Note This interoperability information will be folded into the "Component Interoperability" section of the Release 6.0 Cisco BTS 10200 Softswitch Release Notes.


The provisioning on the BTS 10200 for the SIP trunk to the Cisco 2811 is the same as provisioned for any SIP trunk. See the Release 6.0 Cisco BTS 10200 Softswitch SIP Feature and Provisioning Guide for SIP trunk provisioning information.

The SIP to ISDN (PRI) conversion mapping is an existing IOS function and is documented in the applicable Cisco IOS software guide:

http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/products_configuration_guide_chapter09186a00807561f8.html#wp1047641