Billing Guide - Appendix F - ENUM Capability [Cisco BTS 10200 Softswitch]

Table Of Contents

Enum Capability

Billing Fields

Enum Capability

Revised: January 5, 2009, OL-12778-14

This appendix describes the effect of the Enum Capability feature introduced in Release 5.0 of BTS 10200 Softswitch on the billing fields.

Note For more details on the ENUM Capability feature, refer to Cisco BTS 10200 Softswitch Network and Subscriber Feature Descriptions Guide.

Billing Fields

The system captures the following information in the call detail records (CDR):

•Whether the ENUM query was performed for the call and the result of the query (success/failure)

•Time stamp

•URI returned from the ENUM server

Note If multiple URIs are returned, the BTS 10200 captures only the URI that has the highest priority after the ENUM response processing.

The system adds the ENUM-ROUTE-USED flag to the CDR. The flag is set to Y if you select on-net route to route the call as specified by the E2U+SIP NAPTR record in the ENUM server and the domain2route table in the BTS 10200.

	Billing Guide
	Appendix F - ENUM Capability
Billing Guide Preface Chapter 1 - Operational Procedures Chapter 2 - Feature Server Derived Call Data Appendix A - Call Detail Block File Fields Appendix B - Call Termination Cause Codes Appendix C - Example Call Detail Block File Appendix D - Time Zone Mapping Table Appendix E - QoS Metrics Captured in CDRs Appendix F - ENUM Capability 5.0 Billing Guide Changes	Download this chapter Appendix F - ENUM Capability Download the complete book Billing Guide - Book Length PDF (PDF - 2 MB) Table Of Contents Enum Capability Billing Fields Enum Capability Revised: January 5, 2009, OL-12778-14 This appendix describes the effect of the Enum Capability feature introduced in Release 5.0 of BTS 10200 Softswitch on the billing fields. Note For more details on the ENUM Capability feature, refer to Cisco BTS 10200 Softswitch Network and Subscriber Feature Descriptions Guide. Billing Fields The system captures the following information in the call detail records (CDR): •Whether the ENUM query was performed for the call and the result of the query (success/failure) •Time stamp •URI returned from the ENUM server Note If multiple URIs are returned, the BTS 10200 captures only the URI that has the highest priority after the ENUM response processing. The system adds the ENUM-ROUTE-USED flag to the CDR. The flag is set to Y if you select on-net route to route the call as specified by the E2U+SIP NAPTR record in the ENUM server and the domain2route table in the BTS 10200.
	© 1992-2009 Cisco Systems, Inc. All rights reserved. Terms & Conditions \| Privacy Statement \| Cookie Policy \| Trademarks of Cisco Systems, Inc.