Table Of Contents

Sample Configuration Files

SIP Phone Market-Specific Configuration

China Dial Plan

Using a Cisco 7960 SIP Phone

Using a Cisco 7905 SIP Phone

North America Dial Plan

Using a Cisco 7960 SIP Phone

Using a Cisco 7905 SIP Phone

Cisco IP Phone 7960 Sample Configuration File

Cisco IP Phone 7905 Sample Configuration File

Sample Configuration Files

---

SIP Phone Market-Specific Configuration

For information about dial plans for other countries, contact Cisco support.

---

Note The provisioning in these examples is based on Cisco BTS 10200 Release 4.2.

---

China Dial Plan

Using a Cisco 7960 SIP Phone

A file (xxxx.xml) with the following dial_plan must be stored in the same directory as the SIP<mac>.cnf to support the China dialplan.

Add the dial_template: "china_dialplan.xml."

china_dialplan.xml 

<DIALTEMPLATE>

	 <TEMPLATE MATCH="11."        Route="Default"    Timeout="0"    User="Phone"/> <!-- ->

	<TEMPLATE MATCH="........" Route="Default"    Timeout="0" User="Phone"/> <!-- -->

	<TEMPLATE MATCH="01.11."    Route="Default"    Timeout="0"    User="Phone"/>  <!-- -->

	<TEMPLATE MATCH="02.11."    Route="Default"    Timeout="0"    User="Phone"/>  <!-- -->

	<TEMPLATE MATCH="0...11."   Route="Default"    Timeout="0"    User="Phone"/> <!-- -->

	<TEMPLATE MATCH="00......*"  Route="Default"    Timeout="2"    User="Phone"/> <!-- -->

	<TEMPLATE MATCH="01........." Route="Default"    Timeout="0" User="Phone"/> <!-- -->

	<TEMPLATE MATCH="02........." Route="Default"    Timeout="0" User="Phone"/> <!-- -->

	<TEMPLATE MATCH="\*..\**"   Route="Default"    Timeout="2"    User="Phone"/>    <!-- 
-->

	 <TEMPLATE MATCH="#..\**"    Route="Default"    Timeout="2"    User="Phone"/> <!-- -->

	<TEMPLATE MATCH="\*..#*"    Route="Default"    Timeout="0"    User="Phone"/> <!--  -->

	<TEMPLATE MATCH="#..#"       Route="Default"    Timeout="0"    User="Phone"/> <!-- -->

	 <TEMPLATE MATCH="179.*"   Route="Default"    Timeout="2"    User="Phone"/> <!--  -->

	 <TEMPLATE MATCH="............." Route="Default" Timeout="2" User="Phone"/> <!--  -->

	 <TEMPLATE MATCH="*"      Route="Default"    Timeout="2"    User="Phone"/> <!--  -->

</DIALTEMPLATE>

Using a Cisco 7905 SIP Phone

---

Step 1 Add the following line to ld<macaddr>.txt file.

Step 2 Convert it to binary by using cfgfmt.exe and upload the file to the TFTP server.

dial_plan: 
11.|........|01.11.|02.11.|0...11.|00.....St2-|01.........|02.........|0..........|*..*St2
-|#..#|*#..*St2-|#..*St2-|179.St2-|......................

---

North America Dial Plan

Using a Cisco 7960 SIP Phone

Refer to the Cisco SIP IP Phone 7940/7960 Administrator Guide, Version 4.0.

Using a Cisco 7905 SIP Phone

For further details refer to the Cisco IP Phone 7905 Series Administration Guide.

Cisco IP Phone 7960 Sample Configuration File

##########################################################

SIPDefault.cnf file

##########################################################

# Image Version

image_version: "P0S3-WF-X-20"

# Proxy Server

proxy1_address: "10.89.224.18"

proxy2_address: ""

proxy3_address: ""

proxy4_address: ""

proxy5_address: ""

proxy6_address: ""

# Proxy Server Port (default - 5060)

proxy1_port:"5060"

proxy2_port:""

proxy3_port:""

proxy4_port:""

proxy5_port:""

proxy6_port:""

# Emergency Proxy info

proxy_emergency: "10.89.224.18"

proxy_emergency_port: "5060"

# Backup Proxy info

proxy_backup: "10.89.224.18"

proxy_backup_port: "5060"

# Proxy Registration (0-disable (default), 1-enable)

proxy_register: "1"

# Phone Registration Expiration [1-3932100 sec] (Default - 3600)

timer_register_expires: "3600"

# Codec for media stream (g711ulaw (default), g711alaw, g729)

preferred_codec: "g711ulaw"

# TOS bits in media stream [0-5] (Default - 5)

tos_media: "5"

# Enable VAD (0-disable (default), 1-enable)

enable_vad: "0"

# Inband DTMF Settings (0-disable, 1-enable (default))

dtmf_inband: "1"

# Out of band DTMF Settings (none-disable, avt-avt enable (default), avt_always - always 
avt)

dtmf_outofband: "avt"

# DTMF dB Level Settings (1-6dB down, 2-3db down, 3-nominal (default), 4-3db up, 5-6dB up)

dtmf_db_level: "3"

# SIP Timers

timer_t1: "500"                   ; Default 500 msec

timer_t2: "4000"                  ; Default 4 sec

sip_retx: "10"                     ; Default 11

sip_invite_retx: "6"               ; Default 7

timer_invite_expires: "180"        ; Default 180 sec

# Setting for Message speeddial to UOne box

messages_uri: "9195551212"

#*********  Release 2 new config parameters **********

# TFTP Phone Specific Configuration File Directory

tftp_cfg_dir: "./sip_phone/"

# Time Server

sntp_mode: "directedbroadcast"

sntp_server: "171.68.10.150"

time_zone: "EST"

dst_offset: "+1"

dst_start_month: "April"

dst_start_day: ""

dst_start_day_of_week: "Sunday"

dst_start_week_of_month: "1"

dst_start_time: "02/00"

dst_stop_month: "Oct"

dst_stop_day: ""

dst_stop_day_of_week: "Sunday"

dst_stop_week_of_month: "8"

dst_stop_time: "02/00"

dst_auto_adjust: "1"

# Do Not Disturb Control (0-off, 1-on, 2-off with no user control, 3-on with no user 
control)

dnd_control: "0"                  ; Default 0 (Do Not Disturb feature is off)

# Caller ID Blocking (0-disabled, 1-enabled, 2-disabled no user control, 3-enabled no user 
con

trol)

callerid_blocking: "0"            ; Default 0 (Disable sending all calls as anonymous)

# Anonymous Call Blocking (0-disabled, 1-enabled, 2-disabled no user control, 3-enabled no 
use

r control)

anonymous_call_block: "0"         ; Default 0 (Disable blocking of anonymous calls)

# DTMF AVT Payload (Dynamic payload range for AVT tones - 96-127)

dtmf_avt_payload: "101"           ; Default 100

# XML file that specifies the dialplan desired

dial_template: "dialplan"

# Network Media Type (auto, full100, full10, half100, half10)

network_media_type: "auto"

#Autocompletion During Dial (0-off, 1-on [default])

autocomplete: "1"

#Time Format (0-12hr, 1-24hr [default])

time_format_24hr: "0"

# Services URL points to XML on Stan-btc

services_url: "http://64.101.150.57/servlet/FeatureProvisioning"

# services_url: "http://64.101.150.57/servlet/CallForwarding"

# Enable telnet debugging

telnet_level: 2

##########################################################

##########################################################

# SIP0008ABC456.cnf

##########################################################

# SIP Confiuration Generic File (start)

# Line 1 Settings

line1_name: "9022551232"                     ; Line 1 Extension\User ID

line1_displayname: "SIP8"           ; Line 1 Display Name

line1_authname: "UNPROVISIONED"         ; Line 1 Registration Authentication

line1_password: "UNPROVISIONED"         ; Line 1 Registration Password

proxy1_address: 10.89.224.63

proxy1_port: 5060

# Line 2 Settings

line2_name: ""                    ; Line 2 Extension\User ID

line2_displayname: ""                ; Line 2 Display Name

line2_authname: "UNPROVISIONED"         ; Line 2 Registration Authentication

line2_password: "UNPROVISIONED"         ; Line 2 Registration Password

# Line 3 Settings

line3_name: ""                          ; Line 3 Extension\User ID

line3_displayname: ""                   ; Line 3 Display Name

line3_authname: "UNPROVISIONED"         ; Line 3 Registration Authentication

line3_password: "UNPROVISIONED"         ; Line 3 Registration Password

# Line 4 Settings

line4_name: ""                          ; Line 4 Extension\User ID

line4_displayname: ""                   ; Line 4 Display Name

line4_authname: "UNPROVISIONED"         ; Line 4 Registration Authentication

line4_password: "UNPROVISIONED"         ; Line 4 Registration Password

# Line 5 Settings

line5_name: ""                          ; Line 5 Extension\User ID

line5_displayname: ""                   ; Line 5 Display Name

line5_authname: "UNPROVISIONED"         ; Line 5 Registration Authentication

line5_password: "UNPROVISIONED"         ; Line 5 Registration Password

# Line 6 Settings

line6_name: ""                          ; Line 6 Extension\User ID

line6_displayname: ""                   ; Line 6 Display Name

line6_authname: "UNPROVISIONED"         ; Line 6 Registration Authentication

line6_password: "UNPROVISIONED"         ; Line 6 Registration Password

# Phone Label (Text desired to be displayed in upper right corner)

phone_label: "SIP Phone 8"            ; Has no effect on SIP messaging

# Time Zone phone will reside in

time_zone: CST

# XML file that specifies the dialplan desired

dial_template: "dialplan"

# SIP Configuration Generic File (stop)

##########################################################

Cisco IP Phone 7905 Sample Configuration File

ld0008a3d31e4a.txt 

#tx

upgradecode:3,0x501,0x0400,0x0100,2.3.4.5,69,0x030218A,LD0101SIP030218A.zup

UIPassword:Cisco         

dhcp:1

Proxy:1.2.3.4

UID:4692557907

PWD:user

LoginID:user

UseLoginID:1

SIPRegOn:1

RxCodec:2

TxCodec:2

Timezone:20

DNS1IP:0.0.0.0

UseTftp:1