- Preface
- Chapter 1, Shelf Assembly Hardware
- Chapter 2, Common Control Cards
- Chapter 3, Optical Service Channel Cards
- Chapter 4, Optical Amplifier Cards
- Chapter 5, Multiplexer and Demultiplexer Cards
- Chapter 6, Tunable Dispersion Compensating Units
- Chapter 7, PSM Card
- Chapter 8, Optical Add/Drop Cards
- Chapter 9, Reconfigurable Optical Add/Drop Cards
- Chapter 10, Transponder and Muxponder Cards
- Chapter 11, Node Reference
- Chapter 12, Network Reference
- Chapter 13, Optical Channel Circuits and Virtual Patchcords Reference
- Chapter 14, Cisco Transport Controller Operation
- Chapter 15, Security Reference
- Chapter 16, Timing Reference
- Chapter 17, Manage Network Connectivity
- Chapter 18, Alarm and TCA Monitoring and Management
- Chapter 19, Performance Monitoring
- Chapter 20, SNMP
- Appendix A, Hardware Specifications
- Appendix B, Administrative and Service States
- Appendix C, Pseudo Command Line Reference
- Appendix D, Connector Losses in Raman Link Configuration
- Appendix E, Network Element Defaults
- B.1 Service States
- B.2 Administrative States
- B.3 Service State Transitions
- B.3.1 DWDM Shelf Service State Transitions
- B.3.2 DWDM Card Service State Transitions
- B.3.3 Optical Payload Port Service State Transitions
- B.3.4 OSC Port Service State Transitions
- B.3.5 OCHNC, OCHCC, and OCH-Trail Service State Transitions
- B.3.6 Transponder/Muxponder Card Service State Transitions
- B.3.7 Transponder/ Muxponder Port Service State Transitions
Administrative and Service States
This appendix describes the administrative and service states for Cisco ONS 15454 dense wavelength division multiplexing (DWDM) cards, optical payload ports, out-of-band optical service channel (OSC) ports, optical channel network connections (OCHNCs), and transponder/muxponder cards and ports. States for Software Release 5.0 and later are based on the generic state model defined in Telcordia GR-1093-Core, Issue 2 and ITU-T X.731.
B.1 Service States
Service states include a Primary State (PST), a Primary State Qualifier (PSTQ), and one or more Secondary States (SST). Table B-1 lists the ANSI and ETSI service state PSTs and PSTQs supported by the ONS 15454.
Table B-2 defines the ANSI and ETSI SSTs supported by the ONS 15454.
B.2 Administrative States
Administrative states are used to manage service states. Administrative states consist of a PST and an SST. Table B-3 lists the ANSI and ETSI administrative states supported by the ONS 15454. See Table B-2 for SST definitions.

Note A change in the administrative state of an entity does not change the service state of supporting or supported entities.
|
|
|
---|---|---|
The administrative state of a port immediately transitions to IS when these three conditions exist:
B.3 Service State Transitions
This section describes the transition from one service state to the next state for DWDM shelves, cards, optical payload ports, OSC ports, OCHNCs, and transponder/muxponder cards and ports. A service state transition is based on the action performed on the entity and any autonomous activity.

Note When an entity is put in the OOS,MT administrative state, the ONS node suppresses all standing alarms on that entity. All alarms and events appear on the Conditions tab. You can change this behavior for the LPBKFACILITY and LPBKTERMINAL alarms. To display these alarms on the Alarms tab, set the NODE.general.ReportLoopbackConditionsOnOOS-MTPorts (ANSI) or NODE.general.ReportLoopbackConditionsOnPortsInLocked,Maintenance (ETSI) to TRUE on the NE Defaults tab.
B.3.1 DWDM Shelf Service State Transitions
Table B-4 lists ANSI and ETSI service state transitions for shelf entities.
|
|
|
---|---|---|
Unlocked-disabled,automaticInService & mismatchOfEquipment (ETSI) |
||
Locked-disabled,automaticInService & mismatchOfEquipment (ETSI) |
||
B.3.2 DWDM Card Service State Transitions
Table B-5 lists ANSI and ETSI service state transitions for AD-1B-xx.x, AD-4B-xx.x, AD-1C-xx.x, AD-2C-xx.x, AD-4C-xx.x, OSC-CSM, OSCM, OPT-BST, OPT-BST-E, OPT-BST-L, OPT-AMP-L, OPT-PRE, OPT-AMP-17-C, OPT-AMP-17-C, 4MD-xx.x, 32WSS, 32WSS-L, 32MUX-O, 32DMX, 32DMX-L, 32DMX-O, 40-MUX-C, 40-DMX-C, 40-DMX-CE, 40-WSS-C, 40-WSS-CE, and 40-WXC-C cards.
B.3.3 Optical Payload Port Service State Transitions
Table B-6 lists the ANSI and ETSI optical payload port service state transitions.
B.3.4 OSC Port Service State Transitions
Table B-7 lists the ANSI and ETSI OSC port service state transitions.
B.3.5 OCHNC, OCHCC, and OCH-Trail Service State Transitions
Table B-8 lists the ANSI and ETSI OCHNC, OCHCC, and OCH-Trail service state transitions.
B.3.6 Transponder/Muxponder Card Service State Transitions
Table B-9 lists ANSI and ETSI transponder and muxponder card service state transitions.
B.3.7 Transponder/Muxponder Port Service State Transitions
Table B-10 lists the ANSI and ETSI transponder and muxponder port service state transitions.
|
|
|
---|---|---|
Put the port in the OOS,MT (ANSI) or Locked,maintenance (ETSI) administrative state. |
||
Put the port in the OOS,DSBLD (ANSI) or Locked,disabled (ETSI) administrative state. |
||
Put the port in the IS,AINS (ANSI) or Unlocked,automaticInService (ETSI) administrative state. |
||
Put the port in the IS (ANSI) or Unlocked (ETSI) administrative state. |
IS-NR1 (ANSI) |
|
Put the port in the OOS,MT (ANSI) or Locked,maintenance (ETSI) administrative state. |
||
Put the port in the OOS,DSBLD (ANSI) or Locked,disabled (ETSI) administrative state. |
||
Put the port in the IS (ANSI) or Unlocked (ETSI) administrative state. |
||
Put the port in the OOS,DSBLD (ANSI) or Locked,disabled (ETSI) administrative state. |
||
Put the port in the OOS,MT (ANSI) or Locked,maintenance (ETSI) administrative state. |
||
Put the port in the IS,AINS (ANSI) or Unlocked,automaticInService (ETSI) administrative state. |
||
Put the port in the OOS,DSBLD (ANSI) or Locked,disabled (ETSI) administrative state. |
||
Put the port in the OOS,MT (ANSI) or Locked,maintenance (ETSI) administrative state. |
||
Put the port in the IS (ANSI) or Unlocked-enabled (ETSI) administrative state. |
||
Put the port in the IS,AINS (ANSI) or Unlocked,automaticInService (ETSI) administrative state. |
||
Put the port in the OOS,DSBLD (ANSI) or Locked,disabled (ETSI) administrative state. |
||
Put the port in the IS (ANSI) or Unlocked (ETSI) administrative state. |
IS-NR 1 (ANSI) |
|
Put the port in the IS,AINS (ANSI) or Unlocked,automaticInService (ETSI) administrative state. |
||
Put the port in the OOS,MT (ANSI) or Locked,maintenance (ETSI) administrative state. |
||
Put the port in the IS (ANSI) or Unlocked (ETSI) administrative state. |
IS-NR 1 |
|
Put the port in the IS,AINS (ANSI) or Unlocked,automaticInService (ETSI) administrative state. |
||
Put the port in the OOS,DSBLD (ANSI) or Locked,disabled (ETSI) administrative state. |
||