Cisco Nexus 6000 Series NX-OS Multicast Routing Command Reference
F Commands
Downloads: This chapterpdf (PDF - 73.0KB) The complete bookPDF (PDF - 1.68MB) | Feedback

F Commands

Table Of Contents

F Commands

feature pim


F Commands


This chapter describes the Cisco NX-OS PIM commands that begin with F.

feature pim

To enable Protocol Independent Multicast (PIM), use the feature pim command. To disable PIM, use the no form of this command.

feature pim

no feature pim

Syntax Description

This command has no arguments or keywords.

Command Default

Disabled

Command Modes

Global configuration mode

Command History

Release
Modified

6.0(2)N1(1)

This command was introduced.


Usage Guidelines

You must enable the PIM feature before you can configure PIM.

This command requires the LAN Base Services license.

Examples

This example shows how to enable a PIM configuration:

switch(config)# feature pim 
switch(config#
 
   

Related Commands

Command
Description

show running-configuration pim

Displays the PIM running configuration information.

show feature

Displays the status of features on a switch.

ip pim sparse-mode

Enables IPv4 PIM sparse mode on an interface.