Cisco Nexus 6000 Series NX-OS Multicast Routing Command Reference
H Commands
Downloads: This chapterpdf (PDF - 77.0KB) The complete bookPDF (PDF - 1.68MB) | Feedback

H Commands

Table Of Contents

H Commands

hardware profile multicast max-limit


H Commands


This chapter describes the Cisco NX-OS routing commands that begin with H.

hardware profile multicast max-limit

To set the maximum number of entries in the multicast routing table, use the hardware profile multicast max-limit command.

hardware profile multicast max-limit max-entries

Syntax Description

max-entries

Maximum number of entries in the multicast routing table. The range is from 0 to 8000.


Command Default

None

Command Modes

Global configuration mode

Command History

Release
Modification

6.0(2)N1(1)

This command was introduced.


Usage Guidelines

A reload is neccessary after configuring the max-limit.

This command does not require a license.

Examples

This example shows how to set the maximum number of entries in the multicast routing table to 3000:

switch(config)# hardware profile multicast max-limit 3000 
Warning!!: The multicast and /32 unicast route limits have been changed.
           Any route exceeding the limit may get dropped.
switch(config)#

Related Commands

Command
Description

show hardware profile status

Displays information about the multicast routing table limits.