This document shows how to display an idle URL logo after a preselected
time of inactivity on the Cisco IP Phone 7960/7940 liquid crystal display
Cisco recommends that you have knowledge of Cisco CallManager
administration before you use the information in this document.
The information in this document is based on Cisco CallManager version
3.1 or later.
The information in this document was created from the devices in a
specific lab environment. All of the devices used in this document started with
a cleared (default) configuration. If your network is live, make sure that you
understand the potential impact of any command.
Technical Tips Conventions for more information on document
The idle URL logo does not display on the phone.
Ensure that you have set up the configuration to correctly display idle
URL logos. Complete these steps:
Choose System > Enterprise Parameters from the
Cisco CallManager Administration window.
Enter the URL of the logo that you want to display in the URL Idle
Enter a value that is greater than zero (0) in the URL Idle Time
This value indicates the amount of idle time that passes before
activation of the logo that you selected in Step 2. If you set this value to
zero, the idle URL logo never displays.
Note: The parameters that display in this window are global parameters.
In order to set a different value for a particular phone, change the value of
the URL Idle field and the URL Idle Time field under the phone configuration.
Otherwise, the Idle Timer field in the phone configuration is empty, as this
Note: Choose Device > IP phone > search for your
phone in order to find this phone configuration.