How to Factory Reset Speaker Track on MX series

Available Languages

Updated:July 9, 2018

Document ID:211319

Bias-Free Language

The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.

Introduction

Procedure

Introduction

This document describes how to factory reset the speaker tracker on the MX700/MX800 camera and the entire speaker track on the MX Series.

Procedure

This procedure can also be applied to a MX series with a single camera. Follow Steps 1 through 4.

The front view of the MX Series is as shown in the image.

Step 1. Remove the top cover as shown in the image.

Step 2. Remove the left, right and center speakers next to the cameras as shown in the image.

Step 3. In order to reset the cameras singly, go to the right side of each camera, you can see a fan in each device as shown in the image.

Step 4. In the bottom of the control panel, next to the screw, you can see a pinhole. Press the pinhole with a pen for about 15 seconds until the Light Emitting Diode (LED) of the camera blinks red as shown in the image.

Step 5. In order to reset the speaker track itself, on the left control panel next to the camera as shown in the image.

Step 6. You can find the pinhole on the left bottom, next to the screw, press the pinhole for about 15 seconds, and the speaker tracker resets as shown in the image.