手動ループバック テストを実行すると、スイッチング モジュールまたはサービス モジュールのデータ パスや、スーパーバイザ モジュールの制御パスにおけるハードウェア エラーを特定できます。外部ループバック テストは、同一のポートの間または 2 つのポート間で
FC2 フレームを送受信します。
テストを実行する前に、Rx ポートから Tx ポートへループさせるためにケーブル(またはプラグ)を接続する必要があります。同じポートの間でテストする場合は、特殊なループ ケーブルが必要です。異なるポートとの間でテストする場合は、通常のケーブルを使用できます。このテストを使用できるのは、ファイバ
チャネル インターフェイスだけです。
Use the EXEC-level system health external-loopback interface interface command to run this test on demand for external devices connected to a switch that is part of a long-haul network.
switch# system health external-loopback interface fc 3/1
This will shut the requested interfaces Do you want to continue (y/n)? [n] y
External loopback test on interface fc3/1 was successful.
Sent 1 received 1 frames
Use the EXEC-level system health external-loopback source interface destination interface interface command to run this test on demand between two ports on the switch.
switch# system health external-loopback source interface fc 3/1 destination interface fc 3/2
This will shut the requested interfaces Do you want to continue (y/n)? [n] y
External loopback test on interface fc3/1 and interface fc3/2 was successful.
Sent 1 received 1 frames
Use the EXEC-level system health external-loopback interface frame-count command to run this test on demand for external devices connected to a switch that is part of a long-haul network and override
the frame count configured on the switch.
switch# system health external-loopback interface fc 3/1 frame-count 10
This will shut the requested interfaces Do you want to continue (y/n)? [n] y
External loopback test on interface fc3/1 was successful.
Sent 1 received 1 frames
Use the EXEC-level system health external-loopback interface frame-length command to run this test on demand for external devices connected to a switch that is part of a long-haul network and override
the frame length configured on the switch.
switch# system health external-loopback interface fc 3/1 frame-length 64
This will shut the requested interfaces Do you want to continue (y/n)? [n] y
External loopback test on interface fc3/1 was successful.
Sent 1 received 1 frames
Use the system health external-loopback interface force command to shut down the required interface directly without a back out confirmation.
switch# system health external-loopback interface fc 3/1 force
External loopback test on interface fc3/1 was successful.
Sent 1 received 1 frames
(注) |
テストを正常に完了できない場合、ソフトウェアが障害を分析し、次のエラーを出力します。「インターフェイス fc 7/2 の外部ループバック テストに失敗しました。Failure reason: Failed to loopback, analysis
complete Failed device ID 3 on module 1
|