Step 6
|
show dial-peer voice
Router# show dial-peer voice
VoiceOverIpPeer40036
peer type = voice, information type = voice,
description = `',
tag = 40036, destination-pattern = `91011',
answer-address = `', preference=1,
CLID Restriction = None
CLID Network Number = `'
CLID Second Number sent
source carrier-id = `', target carrier-id = `',
source trunk-group-label = `', target
trunk-group-label = `',
numbering Type = `unknown'
group = 40036, Admin state is up, Operation state is
up,
incoming called-number = `', connections/maximum =
0/unlimited,
! Default output for incoming called-number command
DTMF Relay = disabled,
modem transport = system,
huntstop = disabled,
in bound application associated: 'DEFAULT'
out bound application associated: ''
dnis-map =
permission :both
incoming COR list:maximum capability
! Default output for cor command
outgoing COR list:minimum requirement
! Default output for cor command
Translation profile (Incoming):
Translation profile (Outgoing):
incoming call blocking:
translation-profile = `'
disconnect-cause = `no-service'
advertise 0x40 capacity_update_timer 25 addrFamily 4
oldAddrFamily 4
type = voip, session-target = `ipv4:10.2.161.187',
technology prefix:
settle-call = disabled
ip media DSCP = ef, ip signaling DSCP = af31,
ip video rsvp-none DSCP = af41,ip video rsvp-pass
DSCP = af41
ip video rsvp-fail DSCP = af41,
UDP checksum = disabled,
session-protocol = sipv2, session-transport =
system,
req-qos = best-effort, acc-qos = best-effort,
req-qos video = best-effort, acc-qos video =
best-effort,
req-qos audio def bandwidth = 64, req-qos audio max
bandwidth = 0,
req-qos video def bandwidth = 384, req-qos video max
bandwidth = 0,
RTP dynamic payload type values: NTE = 101
Cisco: NSE=100, fax=96, fax-ack=97, dtmf=121,
fax-relay=122
S=123, ClearChan=125, PCM switch over
u-law=0,A-law=8
RTP comfort noise payload type = 19
fax rate = voice, payload size = 20 bytes
fax protocol = system
fax-relay ecm enable
fax NSF = 0xAD0051 (default)
codec = g729r8, payload size = 20 bytes,
Media Setting = flow-through (global)
Expect factor = 0, Icpif = 20,
Playout Mode is set to adaptive,
Initial 60 ms, Max 300 ms
Playout-delay Minimum mode is set to default, value
40 ms
Fax nominal 300 ms
Max Redirects = 1, signaling-type = cas,
VAD = enabled, Poor QOV Trap = disabled,
Source Interface = NONE
voice class sip url = system,
voice class sip rel1xx = system,
monitor probe method: icmp-ping ip address:
10.2.161.187,
Monitored destination reachable
voice class perm tag = `'
Time elapsed since last clearing of voice call
statistics never
Connect Time = 0, Charged Units = 0,
Successful Calls = 0, Failed Calls = 0, Incomplete
Calls = 0
Accepted Calls = 0, Refused Calls = 0,
Last Disconnect Cause is "",
Last Disconnect Text is "",
Last Setup Time = 0.
|
Use the show dial-peer voice command on dial peer 40036, and notice the monitor probe status.
Note
|
Also highlighted is the output of the cor and incoming called-number commands.
|
|