Cisco VVB Uninstallation on KVM

Cisco VVB Uninstallation on KVM

Uninstall Cisco VVB on KVM

Procedure

Step 1

Deactivate virtual-service from the virtual-service config mode by running:

no activate

Example:

router# configure
Configuring from terminal, memory, or network [terminal]?
Enter configuration commands, one per line.  End with CNTL/Z.
router(config)#
router(config)# virtual-service vvb
router(config-virt-serv)# no activate
router(config-virt-serv)# ^Z
router# show virtual-service list
Virtual Service List:

Name                    Status             Package Name
------------------------------------------------------------------------------


vvb                Deactivating            VVB_12_5_1_ISR4K.ova
Name                    Status             Package Name
------------------------------------------------------------------------------


vvb                Deactivated             VVB_12_5_1_ISR4K.ova

Note

 

This can take around 5-10 minutes.

Step 2

In the privileged EXEC mode, run:

virtual-service uninstall name <name>

Example:

router# virtual-service uninstall name vvb

Note

 

The virtual-service name is case-sensitive and must match the name given in Step 2 of the preceding procedure.

Step 3

To verify the VVB instance was successfully deactivated/uninstalled, run:

  1. show log

    Example:

    router# show log

------------------------------------------------------------------------------
show log
*Aug  1 08:51:48.845: %VIRT_SERVICE-5-ACTIVATION_STATE: Successfully deactivated virtual service vvb
*Aug  1 08:52:45.418: %VIRT_SERVICE-5-INSTALL_STATE: Successfully uninstalled virtual service vvb

  2. show virtual-service list

    Example:

    
router# show virtual-service list
Virtual Service List:

    Note

     

    The output of the command must be empty.