- Index
- Preface
- Introduction
- Managing Services
- Alarm Configuration
- Alarm Definitions
- Trace Configuration
- Troubleshooting Trace Setting Configuration
- Real-Time Monitoring Configuration
- Alert Configuration in RTMT
- Configuring and Using Performance Monitoring
- Trace Collection and Log Central in RTMT
- Using SysLog Viewer in RTMT
- Using Plug-ins
- Log Partition Monitoring Configuration
- CDR Repository Manager Configuration
- Serviceability Reports Archive Configuration
- SNMP V1/V2c Configuration
- SNMP V3 Configuration
- MIB2 System Group Configuration
Cisco Unified Presence Server Serviceability Administration Guide, Release 1.0(1)
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
Chapter: MIB2 System Group Configuration
MIB2 System Group Configuration
Cisco Unified Presence Server Serviceability provides the MIB2 System Group Configuration window where you can configure the system contact and system location objects for the MIB-II system group. For example, you could enter Administrator, 555-121-6633, for the system contact and San Jose, Bldg 23, 2nd floor, for the system location.
Perform the following procedure to configure a system contact and system location for the MIB-II system group.
Tip 
This procedure supports SNMP v1, v2c, and v3 configuration.
Procedure
Step 1 Choose Snmp > SystemGroup Configuration > MIB2 System Group Configuration.
Step 2 From the Server drop-down list box, choose the server for which you want to configure contacts.
Step 3 In the Contact field, enter a person to notify when problems occur.
Step 4 In the System Location field, enter the location of the person that is identified as the system contact.
Step 5 To apply the system configuration to all of the nodes in the cluster, check the Apply To All Nodes check box.
Step 6 Click Save.
A message indicates that changes will not take effect until you restart the SNMP master agent.
Step 7 To continue the configuration without restarting the SNMP master agent service, click Cancel. To restart the SNMP master agent service, click OK.
Note To clear the Contact and System Location fields, click the Clear button. To delete the system configuration, click the Clear button and the Save button.
Additional Information
See the Related Topics.
Related Topics
•Simple Network Management Protocol, Cisco Unified CallManager Serviceability System Guide
•SNMP V1/V2c Configuration, page 16-1
Feedback