Region Matrix Updates
This chapter provides information to use the Region Matrix menu
in BAT to populate or depopulate the region matrix. The region tables define
physical locations, whereas the region matrix tables define available bandwidth
within (intra) and between (inter) regions.
Populate and Depopulate Region Matrix
Use BAT to populate or depopulate the region matrix.
. The Region Matrix Configuration window
Region Matrix Options section, choose
Populate Region Matrix or
Depopulate Region Matrix based on what you want to
Job Information section, enter a name for the
job. This helps you to identify your job.
Run now or
, depending upon when you want to run the job.
Job Scheduler window to check the status of the
job that you submitted.
You can use this window to reschedule the job if required.
Unlike other BAT processes, the progress of a job to populate or
depopulate the region matrix cannot be measured in terms of records passed,
failed, or processed. The results can be viewed only after the entire process
The number of records criterion is not applicable to this
An administrator can change the region bandwidth defaults,
however, this cannot be done through the BAT menu.
Cisco Unified Communications Manager to access the region bandwidth defaults. The
parameter type specifies
Cisco Unified Communications Manager and the four parameters of interest comprise
part of the Clusterwide Parameters (System - Location and Region) section.