1.
On a Windows workstation, sign in to a PIMG unit.
2.
On the Configure menu, select System.
3.
On the System page, enter the following settings.
4.
Select Apply Changes.
5.
On the Configure menu, select Gateway.
6.
On the Gateway page, select the Gateway Routing tab.
7.
On the Gateway Routing tab, Unity Connection without a cluster, skip to Step 8. If Unity Connection has a cluster configured, do the following substeps:
8.
Under VoIP Endpoint ID, enter the following settings.
9.
Select Apply Changes.
10.
Select the Gateway Advanced tab.
11.
On the Gateway Advanced tab, enter the following settings.
12.
Select Apply Changes.
13.
Select the Gateway Capabilities tab.
14.
Depending on how you have planned to use the voice messaging ports, select the applicable setting for each port in the Telephony Port Capability column.
15.
Select Apply Changes.
16.
On the Configure menu, select Serial Protocol.
17.
On the Serial Protocol page, enter the following settings.
18.
Select Apply Changes.
19.
On the Configure menu, select SIP.
20.
On the SIP page, enter the following settings.
21.
Select Apply Changes.
22.
On the Configure menu, select IP.
23.
On the IP page, enter the following settings.
24.
Select Apply Changes.
25.
On the Configure menu, select Tones.
26.
On the Tones page, select the Learn tab.
27.
On the Tones page, for the Dialtone event, confirm that the Acquire Tone check box is checked and leave the Destination Address field blank.
28.
On the Tones page, for the Busy Tone event, confirm that the Acquire Tone check box is checked and do the following substeps to verify that the tone is correct.
29.
On the Tones page, in the Destination Address field for Busy Tone, enter the extension that you dialed in Step 28c. from the third phone.
30.
On the Tones page, for the Error/Reorder Tone event, confirm that the Acquire Tone check box is checked and do the following substeps to verify that the tone is correct.
31.
On the Tones page, in the Destination Address field for Error/Reorder Tone, enter the extension that you dialed in Step 30a.
32.
On the Tones page, for the Ringback Tone event, confirm that the Acquire Tone check box is checked and do the following substeps to verify that the tone is correct.
33.
On the Tones page, in the Destination Address field for Ringback Tone, enter the extension that you dialed in Step 32a.
34.
Select Learn.
35.
When the process is complete, check the check box for each newly learned tone and select Apply.
36.
Hang up the phones that you used in Step 28.
37.
On the Configure menu, select Restart.
38.
On the Restart page, select Restart Unit Now.
39.
When the PIMG unit has restarted, in the View menu, select Refresh.
40.
Repeat Step 1 through Step 39 on all remaining PIMG units.