The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter includes the following section:
After you replace hardware with managed firmware component on a Cisco UCS Manager integrated C-Series server, the server may fail discovery. This could be due to a corrupt firmware on the hardware or incompatibility of the hardware component's firmware. Complete the following steps to ensure server does not fail discovery due to server firmware corruption or incompatibility after hardware replacement:
Step 1 | Right-click Server -> Server Maintenance > Decommission Server to decommission the server. |
Step 2 | Disconnect the cables connecting the VICs to the FI (or FEX, if applicable). |
Step 3 | Remove the server from Cisco UCS Manager: |
Step 4 | Reboot the server and perform a CIMC Reset to Factory Defaults. |
Step 5 | Connect a 1G cable to the MGMT port on the server and configure it for standalone access. |
Step 6 | Re-image all
the server firmware to match the
Cisco UCS Manager firmware bundle CIMC version with the server:
For information about steps to upgrade the firmware, refer to the Host Utility Upgrade User Guide that corresponds to the HUU CIMC version that was downloaded in the previous step. |
Step 7 | Reboot the server and perform a CIMC Reset to Factory Defaults. |
Step 8 | Unplug the power cables for 30 seconds. |
Step 9 | Reconnect the uplink cables. |
Step 10 | Connect the power cables and power on. |
Step 11 | Verify if the server displays on the Cisco UCS Manager, this may take a few minutes. |
Step 12 | After the server appears, re-acknowledge the server, if the rack server discovery policy is set to user acknowledge. |