debug fastethernet
To enable debugging of the Ethernet management port, use the debug fastethernet command in EXEC mode. To disable debugging, use the no form of this command.
debug fastethernet {af | events | packets}
no debug fastethernet {af | events | packets}
Syntax Description
af |
Displays Ethernet management port software-address-filter debug messages. |
events |
Displays Ethernet management port event debug messages. |
packets |
Displays Ethernet management port packet debug messages. |
Command Default
Debugging is disabled.
Command Modes
User EXEC
Privileged EXEC
Usage Guidelines
The undebug fastethernet { af | events | packets } command is the same as the no debug fastethernet {af | events | packets } command.
When you enable debugging on a switch stack, it is enabled only on the active switch. To enable debugging on a member switch, you can start a session from the active switch by using the session switch-number EXEC command. Then enter the debug command at the command-line prompt of the member switch. You also can use the remote command stack-member-number LINE EXEC command on the active switch to enable debugging on a member switch without first starting a session.