New and Changed Information
This table summarizes the new and changed features for the Cisco Nexus 9000 Series NX-OS Security Configuration Guide, Release 9.x and tells you where they are documented.
Feature |
Description |
Changed in Release |
Where Documented |
---|---|---|---|
IP ACLs |
Added the ability to identify traffic using TCP flags. This support is added to Cisco Nexus 9500 platform switches with N9K-X96136YC-R, N9K-X9636C-R, and N9K-X9636C-RX line cards and N9K-C9504-FM-R fabric module. |
9.2(4) |
|
Not applicable |
Changed the document title from 9.x to 9.2(x). |
Not applicable |
Title page |
ACL Statistics |
Added support for ACL statistics on Cisco Nexus 9500 platform switches with -R and -RX line cards. |
9.2(3) |
|
CoPP |
Added the ability to monitor CoPP with SNMP. |
9.2(3) |
|
Label sharing |
Added support for label sharing on Cisco Nexus 9500 platform switches with - R and -RX line cards. |
9.2(3) |
|
RADIUS Change of Authorization |
Introduced this feature. |
9.2(3) |
|
802.1x |
Added 802.1X support for VXLAN EVPN on all Cisco Nexus 9000 Series switches. |
9.2(2) |
|
CoPP |
Added support for protocol ACL filtering at CoPP on Cisco Nexus 9300-EX, 9300-FX, and 9500 platform switches. |
9.2(2) |
|
MACsec EAPOL |
Added the ability to configure the EAPOL destination address and Ethernet type for MACsec. |
9.2(2) |
|
MACsec |
Added the MACsec shutdown feature. This feature disables the MACsec functionality while retaining the MACsec configuration. |
9.2(2) |
|
802.1x |
Added support to multiple authentication, dynamic VLAN, and MAB authentication |
9.2(1) |
|
MACsec |
Added support for Cisco Nexus 93180YC-FX and the Cisco Nexus 93108TC-FX switches. |
9.2(1) |
|
SSH |
Added support for ECDSA, the show rekey command, and the ability to change the default SSHv2 port. |
9.2(1) |
|
Unicast RPF |
Added support for supported for Cisco Nexus 9300-EX Series and Cisco Nexus 9300-FX/FX2 Series switches. |
9.2(1) |