New Commands
The following commands are added in this release.
-
show flow filter
-
show flow profile
-
show flow system [ __readonly__ [ { TABLE_flow_interface [ <intf_name> ] [ <exporter_id> ] [ <profile_name> ] [ <v4in_mon_name> ] [ <v4in_direction> ] [ <v6in_mon_name> ] [ <v6in_direction> ] [ <filter_name> ] } ] ]
-
show icam health [ __readonly__ { <Version> } [ { TABLE_cpu <CpuTypeName> <CpuTypeValue> } ] [ { TABLE_mem <MemTypeName> <MemTypeValue> } ] [ { TABLE_ps <PsTypeName> <PsTypeValue> } ] ]
-
show icam itd [ __readonly__ { <Version> } [ { TABLE_svc <Svc> <DG> [ { TABLE_stats <OrigNode> <AssignTo> <Mode> <PktCnt> <PktPct> } ] } ] ]
-
show lldp traffic interface all [ __readonly__ TABLE_lldp_traffic_interface <interface> <tx_cnt> <aged_cnt> <rx_cnt> <rx_err> <disc_cnt> <unrecognized_tlv> <flap_cnt> ]
-
show logging rfc-strict
-
show port-channel scale-fanout
-
show running-config { analytics | nfm } [ all ]
-
show snmp internal climib mib errorCounterTable entPhysicalIndex <ent_index_in> dev_id <dev_id_in> stats_category <category_in> [ __readonly__ [ TABLE_csstHwInternalErrorTable <ent_index_out> <dev_id_out> <category_out> <device_info> <last_clear_time> ] ]
-
show snmp internal climib mib errorInstCounterTable entPhysicalIndex <ent_index_in> dev_id <dev_id_in> stats_category <category_in> inst_num <inst_num_in> error_id <error_id_in> [ __readonly__ [ TABLE-errorInstCounterTable <ent_index_out> <dev_id_out> <category_out> <inst_num_out> <error_id_out> <error_desc> <error_count> <error_port> ] ]
-
show startup-config { analytics | nfm } [ all ]
-
show system internal icam app hardware capacity forwarding
-
show system internal icam app hardware internal forwarding l2 table utilization instance all
-
show system internal icam app hardware internal forwarding table utilization
-
show system internal icam app health
-
show system internal icam app itd statistics
-
show system internal icam app scale verified
-
show system internal icam app system internal access-list resource utilization
-
show system internal icam app system internal qos resource utilization
-
show system internal icam scale non-mts
-
show system poap
-
show time-stamp running-config last-changed [ __readonly__ <run_config_change_time> ]