The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS commands that begin with T that are used to manage a Cisco Nexus 2000 Series Fabric Extender from a Cisco Nexus 6000 switch.
To set the Fabric Extender card type to a specific card, use the type command. To revert to the default FEX card, use the no form of this command.
Fabric extender configuration mode
|
|
---|---|
The following Cisco Nexus 2000 Series Fabric Extenders are supported on a Cisco Nexus 6000 Series switch:
This example shows how to configure the Fabric Extender card:
|
|
---|---|
Creates a Fabric Extender and enters fabric extender configuration mode. |
|
Displays all configured Fabric Extender chassis connected to the switch. |