The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS quality of service (QoS) commands that begin with L.
To configure the ACL logging process, use the logging ip access-list cache command. To revert to the defaults, use the no form of this command.
logging access-list cache {interval interval | entries number-of-entries | threshold threshold }
no logging access-list cache {interval interval | entries number-of-entries | threshold threshold }
|
|
---|---|
To configure the ACL logging process, you first create the IPv6 access-list with log option enabled, then enable filtering of IPv6 traffic on an interface using the specified ACL, and finally configure the ACL logging process parameters.
This example shows how to set the interval, entries and threshold values for IPv6 ACL logging:
|
|
---|---|