The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS interface commands that begin with U.
To enable and configure the Unidirectional Link Detection (UDLD) protocol on an Ethernet interface, use the udld command. To disable UDLD, use the no form of this command.
udld { aggressive | disable | enable }
no udld { aggressive | disable | enable }
|
|
---|---|
You can configure normal or aggressive UDLD modes for an Ethernet interface. Before you can enable a UDLD mode for an interface, you must make sure that UDLD is enabled on the switch. UDLD must also be enabled on the other linked interface and its device.
To use the normal UDLD mode on a link, you must configure one of the ports for normal mode and configure the port on the other end for the normal or aggressive mode. To use the aggressive UDLD mode, you must configure both ends of the link for aggressive mode.
This example shows how to enable the normal UDLD mode for an Ethernet port:
This example shows how to enable the aggressive UDLD mode for an Ethernet port:
This example shows how to disable UDLD for an Ethernet port:
|
|
---|---|