Shutting Down the APIC System
This procedure explains how to shut down the APIC system.
Note |
After you shut down the system, you will move it (re-locate the entire fabric) then power it up, then update the time zone and/or NTP servers accordingly. |
-
Shut down one Cisco APIC at a time by right-clicking on a controller then choosing Shutdown from the pull-down menu.
-
Start up the APIC at the new location.
-
Check that the cluster has fully converged.
-
Proceed with the next APIC.
Before you begin
Ensure cluster health is fully fit.