- Preface
- GettingStarted
- Creating the Spaces Services
- Adding Devices
- Configurations
- Working with Faults
- Working with the Signage Menu
- Working with the Signage Content
- RoomSetup
- EmergencyDisplay
- Working with Information Signage
- Working with Smart+Connected Green Advisor
- Working with Tools
- Managing Locations
- Managing the Quick Response Codes
- Managing Workspace Features
- Working with Reports
- Usage Scenarios
- Troubleshooting
Cisco Smart+Connected Spaces Administrator Guide
Bias-Free Language
The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
- Updated:
- February 23, 2015
Chapter: Adding Devices
Adding Devices for Interfaces
This chapter describes how to add the devices that are displayed for the interfaces through which the Cisco Smart+Connected Spaces (Smart+Connected Spaces) solution is accessed.
Adding Devices for Room Panels and Cisco IP Phones
The devices configured for a particular location, with which the room panel and/or the IP phone are associated, are displayed for these interfaces. For more information, see the “Managing Configurations for a Location” section and “Adding Configurations” section in Chapter 4, “Working with Configurations”.
Adding Devices for the Calendar
The SSP_DEVICE_TYPE_MASTER table in the Smart+Connected Spaces database contains the data of all the available devices (that you add in SDP). The calendar web interface displays a device only if the appropriate device type is created in SDP and the required configurations changes are carried out. For the required configuration, ensure that:
1.
The appropriate device type is created is SDP. For more information, see the “Adding a Device Type in SDP” section.
2. The value is set as ‘Y’ for each of the device type in the IS_WEB_CAL_DEVICE column of the SSP_DEVICE_TYPE_MASTER table.
Adding a Device Type in SDP
To add a device type in SDP, perform the following steps:
Step 1 Log in to SDP and click Devices > Device Types.
The List of Device Types page appears.
Step 2 In the List of Device Types page, click Create Device Type.
The Create Device Types page appears.
Step 3 Select a Device Category.
Step 4 Select the Manufacturer.
Step 5 Type an appropriate model in the Model field.
The device type gets added and you get an email notification informing you about the same. An ID is also provided. This is the ID that is displayed in the DEVICE_TYPE_MASTER column in the SSP_DEVICE_TYPE_MASTER table.
Note The email notification feature is available only if the SMTP adapter is configured.
Note For more information on devices, see the Cisco Service Delivery Platform User Guide.
Adding Devices for Kiosks
The SPATIAL_HIERARCHY table in the Smart+Connected Spaces database contains the data of all the locations (including the list of preconfigured device types as column names) that are displayed on the kiosks. To enable a device to be displayed as available for a particular location set the value as 'Y', for the associated location and required device.
Feedback