The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter explains how to select the stream transmission mode and saving options on a local computer. When completed with the settings on the Client Settings page, click Save on the page bottom to enable the settings.
Select to stream video or audio data or both. This option is enabled only when the video mode is set to H.264 or H.265.
Depending on your network environment, there are four transmission modes of H.264 or H.265 streaming:
You can record live video as they are watching it by clicking . Start MP4 Recording on the main page. Here, you can specify the storage destination and file name.
Due to the unsteady bandwidth flow, the live streaming may lag and not be very smoothly. If you enable this option, the live streaming will be stored temporarily on your PC’s cache memory for a few seconds before being played on the live viewing window. This will help you see the streaming more smoothly. If you enter 3,000 Millisecond, the streaming will delay for 3 seconds.
Connect a joystick to a USB port on your management computer. Supported by the plug-in (Microsoft DirectX), once the plug-in for the web console is loaded, it will automatically detect if there is any joystick on the computer. The joystick should work properly without installing any other driver or software.
Then you can begin to configure the joystick settings of connected devices.
To enable joystick settings, follow these steps:
Step 1 Select a detected joystick, if there are multiple, from the Selected joystick menu. If your joystick is not detected, if may be defective.
Step 2 Click Calibrate or Configure buttons to configure the joystick-related settings.
Note ● If you want to assign Preset actions to your joystick, the preset locations should be configured in advance in the Configuration > PTZ page.
Click the Configure Buttons button and the Joystick Settings window appears.
To configure your joystick buttons, follow these steps:
Step 1 Select a button number from the Button # pull-down menu.
Tip If you are not sure of the locations of each button, use the Properties window in the Game Controllers utility.
Step 2 Select a corresponding action, such as Patrol or Preset#.
Step 3 Click the Assign button to assign an action to the button. You can delete an association by selecting a button number, and then click the Delete button.
Repeat the process until you are done with the configuration of all preferred actions.
The buttons you define should appear on the button list accordingly.
Step 4 Click the Save button on the Client settings page to preserver your settings.