The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
A
acoustic noise specification
See noise specification
altitude specifications A-1
B
basic configuration 2-5
C
command line interface (CLI) 2-5
commands
configuration 2-5
configure 2-5
interface 2-5
troubleshooting 2-7
compliance 2-12
configuration
commands 2-5
mode 2-5
parameters 2-5
configuration parameters
flow control 2-5
MAC address 2-5
MTU 2-5
configure command 2-5
console logs 2-7
D
document organization 1-x
E
Ethernet line cards
power consumption A-2
specifications A-2
EXEC mode 2-5
F
Fan tray power consumption A-2
flow control 2-5
H
humidity guidelines A-1
I
initial boot process 2-1
installation
troubleshooting 2-3
interface (global) command B-21, B-23
interface address 2-5
interface command 2-5
interface configuration mode 2-5
interfaces
configuring 2-4
interface address 2-5
troubleshooting 2-4
ISM (Integrated Service Module) line card 1-29
L
laser safety 2-12
laser warning 2-12
LED
line cards
basic configuration 2-5
interface address 2-5
removal and installation 1-15
specifications A-1
troubleshooting 2-7
M
MAC address 2-5
maximum transmission unit (MTU) 2-5
MTU (maximum transmission unit) 2-5
N
noise specification A-1
O
OIR (online insertion and removal)
for SPAs 1-27
P
parameters
configuration 2-5
pre-installation information 1-1
R
regulatory information 2-12
RSP card
power consumption A-2
specifications A-2
S
safety information 2-12
SAM Attention LED 1-29, 2-2, 2-3
SAM Flash Module Active LED 1-29, 2-2, 2-3
SAM Flash Module Fault LED 1-29, 2-2, 2-3
Services Acceleration Module 1-29
shock specifications, system A-2
specifications
acoustic noise A-1
altitude A-1
humidity A-1
line cards A-1
shock A-2
temperature A-1
vibration A-2
syslog 2-7
T
temperature
system specifications A-1
troubleshooting
advanced 2-7
commands 2-7
console logs 2-7
line cards 2-7
syslog 2-7
troubleshooting commands
show context slot 2-7
show diag slot 2-7
show logging 2-7
show running config 2-7
show stacks 2-7
show-tech support 2-7
show version 2-7
troubleshooting the installation 2-3
U
Using show Commands to Display Interface Information 1-30
Using show Commands to Verify the VIP4 Status 1-30
V
Verifying the VIP4 Installation 1-29
vibration specifications, system A-2