Name field
|
The
name that you want to assign to the flow.
Note
|
You cannot change the name of the flow entry after it is saved.
|
|
Select a Node drop-down list
|
Select a node name for the device.
Note
|
The node you choose cannot be changed one you save the flow
entry.
|
|
Input Port drop-down list
|
Choose the port on the node where traffic enters the flow.
|
Priority field
|
The
priority that you want to apply to the flow. The default priority is 500. Flows
with a higher priority are given precedence over flows with a lower priority.
Note
|
The priority is considered only when all of the Layer 2, Layer
3, and Layer 4 match fields are equal.
|
|
Hard Timeout field
|
The
amount of time in milliseconds for the flow to be installed before it is
removed from the flow table.
|
Idle Timeout field
|
The
amount of time in milliseconds that the flow can be idle before it is removed
from the flow table.
|
Layer 2
|
|
Ethernet Type field
|
The Ethernet type for the Layer 2 traffic. The Ethernet type for IPv4, in hexadecimal format, is displayed by default. Either
accept the default value, or enter one of the following, in hexadecimal format:
|
VLAN Identification Number field
|
The
VLAN ID for the Layer 2 traffic.
|
VLAN Priority field
|
The
VLAN priority for the Layer 2 traffic.
|
Source MAC Address field
|
The
source MAC address for the Layer 2 traffic.
|
Destination MAC Address field
|
The
destination MAC address for the Layer 2 traffic.
|
Layer 4
|
|
Source Port field
|
The
source port of the Layer 4 traffic.
|
Destination Port field
|
The
destination port of the Layer 4 traffic.
|
Protocol field
|
The
Internet protocol number of the Layer 4 traffic. Enter the IP protocol number
in decimal, hexadecimal, or octal format.
|
Actions drop-down list
|
Select an action from the drop-down list.
|