Distributed Server Installation
This section describes how to install WAE Automation software in a multiple-server deployment where the primary server is designated as the Planning server. In a dual-server deployment, the secondary server is referred to as the Automation server.
Before You Begin
Complete the software installation on the primary (Planning) server. For more information, see
WAE Planning Software Installation
Confirm that system requirements for a multiple-server deployment have been met. For more information, see the
Confirm that the same WAE user exists on all servers and has Sudo access.
Decide on installation type: Dual-server or 5-server deployment.
for a list of services and software installed on each server.
Step 1 Navigate to the appropriate installation template file from $WAE_ROOT/software/wae-platsvcs/confmgmt/etc/:
2node.yml—Installation template file to be used in a dual-server environment.
5node.yml—Installation template file to be used in a 5-server environment.
Step 2 Edit the template file by entering the following information:
(optional) NTP server address—Configures WAE client to point to the NTP server. This option assumes that NTP configuration and an NTP server exist. This option does not install NTP software or services.
IP addresses of the planning (local) server
IP addresses and names of additional servers in your deployment
Services (roles) that you want to run on each server
# 2 node deployment template - address: 184.108.40.206 #Please enter valid IP address these components - address: 220.127.116.11 #Please enter valid IP address
Step 3 Run the wae_dist_deploy installer:
wae_dist_deploy -template-file <install_template.yml> -deploy
wae_dist_deploy -template-file 2node.yml -deploy
Step 4 When prompted, enter the WAE user password.
Wait at least 5 minutes for the deployment to complete. A confirmation message appears when the installation is successful.
Step 5 To verify if the deployment was successful:
wae_dist_deploy -template-file <install_template.yml> -config-test <config_test_option>
can be one of the following:
—Lists status for applicable services running on each server.
—Tests and lists bundled core services.
—Tests and lists the TCP ports of services on the servers.
—Tests if required licenses are installed for each server.
—Lists all available tests.
—Runs all available tests.
wae_dist_deploy -template-file 2node.yml -config-test ports
Note To find all available options for -config-test, enter
wae_dist_deploy -template-file <install_template.yml> -config-test :list.