Configure Protocols for CLI Sessions
Many Prime Infrastructure wireless features, such as autonomous access point and controller command-line interface (CLI) templates and migration templates, require executing CLI commands on the autonomous access point or controller. These CLI commands can be entered by establishing Telnet or SSH sessions. The CLI session page allows you to select the session protocol.
In CLI templates, you are not required to answer the question responses (such as Yes or No answer to a command, Press enter to continue , and so on.). This is automatically performed by Prime Infrastructure.
Select the Controller Session Protocol (you can choose SSH or Telnet; SSH is the default).
Select the Autonomous AP Session Protocol (you can choose SSH or Telnet; SSH is the default).
The Run Autonomous AP Migration Analysis on discovery radio button is set to No by default. Choose Yes if you want to discover the autonomous APs as well as perform migration analysis