New and Changed Information
The following tables provide an overview of the significant changes to this guide up to this current release. The table does not provide an exhaustive list of all changes made to the guide or of the new features up to this release.
|
Feature |
Description |
Where Documented |
|---|---|---|
|
DHCP server preference |
When configuring a DHCP server policy, you can now use the DHCP Server Preference option to select the administrative preference value for this provider. Using the value in this field, the leaf switch determines whether to route the DHCP relay packets from the client VRF or the server VRF. |
|
|
Support for DHCPv6 Option 79 |
You can configure bridge domains configured as DHCP relay agents to include DHCPv6 Option 79. When Option 79 is enabled, the leaf switch with the bridge domain configured as the relay agent includes the client's link-layer address through option 79 of the DHCPv6 relay packet. |
|
|
ssl now an option for the transport protocol for the syslog messages |
For releases prior to release 5.2(4), when creating a syslog remote destination, tcp and udp are the only options for the transport protocol for the syslog messages. In the 5.2(4) release and later, ssl is now an option for the transport protocol for syslog messages. This feature enables a Cisco ACI switch (acting as a client) to make a secure, encrypted outbound connection to remote syslog servers (acting as a server) supporting secure connectivity for logging. With authentication and encryption, this feature allows for a secure communication over an insecure network |
|
|
Support for MCP strict mode |
In MCP strict mode, when an MCP-enabled port is up, the link is checked for loops before data traffic is accepted. The Creating a Mis-cabling Protocol Interface Policy GUI has been updated to indicate support for strict mode. |
|
|
Electromagnetic interference retrain |
The electromagnetic interference (EMI) retrain feature filters any noise on a link due to electromagnetic interference, and retrains the link to avoid a link flap. Enable EMI retrain if your data center environment has a lot of EMI noise. |
|
Feature |
Description |
Where Documented |
|---|---|---|
|
Rogue/COOP exception list |
The rogue/COOP exception list enables you to specify the MAC address of endpoints for which you want to have a higher tolerance for endpoint movement with rogue endpoint control before the endpoints get marked as rogue. Endpoints in the rogue/COOP exception list get marked as rogue only if they move 3000 or more times within 10 minutes. After an endpoint is marked as rogue, the endpoint is kept static to prevent learning. The rogue endpoint is deleted after 30 seconds. |
|
Feature |
Description |
Where Documented |
|---|---|---|
|
Support for intra-EPG contracts on L3Out EPGs |
Intra-EPG contracts are supported on L3Out EPGs. The action can be permit, deny, or redirect. |
Feedback