How to Move UCCX Classic Licenses

Introduction

The article describes the process of moving Unified Contact Center Express (UCCX) Classic licenses between devices.

Prerequisites

Before you start, ensure that you have the following data at your disposal:

• Active Cisco.com account
• MAC address of the source and destination device

Moving UCCX Classic Licenses

Step 1: 

Go to Cisco Software Central and log in with your Cisco.com account.

Step 2:

In the Traditional Licensessection, click Access LRP.

Step 3:

In the Show Smart Account and Virtual Account drop-down lists, confirm that the correct respective accounts are selected.

Note: If the system displays the Welcome To The License Registration Portal alert dialog box, you can select Do not show this message again to prevent it from being displayed again.

Step 4:

On the Devices tab, select the source device from which you need to move the licenses to the target device. Click the blue circled chevron icon and select Move Licenses Between Devices.

Note: If you cannot find the source device information on the Devices tab, you need to add the source device to the list by clicking the Add Devices button.

Step 5:

On the Move Licenses Between Devices page, in Step 1 Select Devices, in the Move Licenses from this Source Device section, verify that the device information is accurate, and then click Next.

Step 6:

In the Move Licenses to this Destination Device section, enter the MAC address of the device to which you need to move the licenses. Optionally, you can also confirm that a correct Smart and Virtual Account is selected. Click Next.

Note: The information requested in the Move Licenses to this Destination Device section varies depending on a product for which you need to move the licenses

Step 7:

In Step 2 Select Licenses, in the Select the Licenses to be Moved section, enter the number of licenses you need to move to a target device, and then click Next.

Note: For some license types you can only select a single license transaction to move all of the licenses over to a target device.

Step 8:

In Step 3 Review, in the Review the Licenses to be Moved section, verify that the Source and Destination Device as well as Source and Destination License(s) and their Quantity are correct. In the Send Licenses To section, you can edit the End User and Email Addresses, to which you need to send the license information. Click Submit.

Step 9:

In the Next Steps section, the system displays a confirmation message about successfully generated license files for the destination device. To download the licenses, click the Download Licenses button. You should also receive the license files to your email within an hour from submitting the License Agreement. 

Caution: Since the email with the license files is sent from do-not-reply@cisco.com, ensure that you check your junk email folder.

Troubleshooting

If you experience an issue during the process of moving licenses between devices or in case you need to add or change the secondary device information, open a case inSupport Case Manager (SCM). 

Next Steps

After you receive a license key file, refer to the product configuration guide for license installation and guidance. If you experience an issue with your installation, contact Cisco Technical Assistance Center (TAC).