Downloads |
Document ID: 12151
Interactive: This document offers customized analysis of your Cisco device.
Contents
Introduction
Prerequisites
Requirements
Components Used
Conventions
Main Flowchart
Troubleshoot OSPF Neighbor States
Troubleshoot the OSPF Routing Table
Troubleshoot OSPF Init State
Troubleshoot OSPF MTU
Troubleshoot OSPF Corrupt Packets
Troubleshoot OSPF Two-Way State
Troubleshoot OSPF Links
Troubleshoot Full Adjacency
Troubleshoot External Link-State Advertisements
Troubleshoot OSPF NBMA Networks
Troubleshoot Access Lists
Troubleshoot Neighbors over PRI
Troubleshoot Ping
Troubleshoot the OSPF Interface
Troubleshoot Frame Relay Environment
Troubleshoot External Route Problems
Troubleshoot Network Type
Troubleshoot OSPF Area Type
Troubleshoot the Hello/Dead Interval
NetPro Discussion Forums - Featured Conversations
Related Information
Introduction
This document provides troubleshooting information for common problems with Open Shortest Path First (OSPF). To see more infomation, or to go to the next flowchart, click the command boxes in red.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Main Flowchart
If you have the output of a show ip ospf
neighbor, show ip ospf neighbor, or
show tech-support command from your Cisco device,
you can use
Output Interpreter
(
registered customers only)
to display
potential issues and fixes. To use Output Interpreter, you must have JavaScript
enabled.
Troubleshoot OSPF Neighbor States
Refer to OSPF Neighbor States for neighbor state descriptions.
Troubleshoot the OSPF Routing Table
Troubleshoot OSPF Init State
Refer to Why Does the show ip ospf neighbor Command Reveal Neighbors in the Init State? for an Init State problem description and troubleshooting steps.
Troubleshoot OSPF MTU
Troubleshoot OSPF Corrupt Packets
Troubleshoot OSPF Two-Way State
Refer to Why Does the show ip ospf neighbor Command Reveal Neighbors Stuck in 2-Way State? for an OSPF Two-way State problem description and troubleshooting steps.
Troubleshoot OSPF Links
Troubleshoot Full Adjacency
Troubleshoot External Link-State Advertisements
Refer to Common Routing Problem with OSPF Forwarding Address for a description of forwarding addresses in external LSA, and for troubleshoot steps concerning the most common problems with LSAs having non-zero forwarding addresses.
Troubleshoot OSPF NBMA Networks
Refer to Problems with Running OSPF in NBMA Mode over Frame Relay for more information on common OSPF over NBMA network problems.
Troubleshoot Access Lists
Troubleshoot Neighbors over PRI
Troubleshoot Ping
Troubleshoot the OSPF Interface
Troubleshoot Frame Relay Environment
Troubleshoot External Route Problems
Troubleshoot Network Type
Troubleshoot OSPF Area Type
Troubleshoot the Hello/Dead Interval
NetPro Discussion Forums - Featured Conversations
| NetPro Discussion Forums - Featured Conversations for RP |
| Service Providers: MPLS |
| Virtual Private Networks: Services |
| Virtual Private Networks: Security |
Related Information
| Updated: Sep 15, 2008 | Document ID: 12151 |