Document ID: 115905
Updated: Feb 11, 2013
Contributed by Anuj Bhatia, Cisco TAC Engineer.
Contents
Introduction
This document answers two of the most frequently asked questions (FAQs) about the Unified Contact Center Enterprise (UCCE) Release 8.X Session Initiation Protocol (SIP) Dialer Call Progress Analysis (CPA) setting in the Dialer registry and in the Campaign Manager > Campaign Purpose tab.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Q. What is the significance of the CPA values in the Dialer registry if the recommendation is to tweak them in the Campaign Purpose tab under Administrator Workstation (AW)?
A. The CPA values must be configured in the Campaign Manager settings, as well as the Dialer registries. This is because personal callback records can exist without the campaigns. In this scenario, the Dialer uses the CPA settings configured in the Dialer registries for CPA analysis.
Q. Should the Dialer CPA registry settings match the system default CPA values?
A. The recommended CPA values for the Dialer registry are as follows:
CPAAnalysisPeriod=2500 CPAMaxTimeAnalysis=3000 CPAMinSilencePeriod=375 CPAMaxTermToneAnalysis=15000 CPANoiseThresholdPeriod=100 CPAJitterBufferDelay=150 ms
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.