Document ID: 113013
Updated: May 24, 2011
Contents
Introduction
This document discusses how to troubleshoot the Add to Cluster is failed because of ClusterException invalid AdminPwd error message received when the user adds a second node to the cluster with Cisco Unified Contact Center Express (UCCX) 7.x.
Prerequisites
Requirements
There are no specific requirements for this document.
Components Used
The information in this document is based on the Cisco UCCX 7.x.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Conventions
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Problem
When trying to add the second node to the cluster using Cisco UCCX 7.x, the Add to Cluster is failed because of ClusterException invalid AdminPwd error message is received.
This issue is documented by Cisco Bug ID CSCsy13029 (registered customers only) .
Solution
Perform these steps in order to resolve this issue:
-
After you RDP/VNC into the server, go to Start > Programs > CCX Administrator > Cisco Unified CCX Admin Utility in order to launch the Admin Utility.
-
Log in with the Admin password, and reset the password for the CRSAdministrator account.
-
Select the CRSAdministrator checkbox for User, and click the Option tab.
-
Click Set New Password, and then set the same password on both servers.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.