This document describes one reason why the caller does not hear a ring back when a call is delivered to the agent, and provides a solution in a Cisco IP Contact Center (IPCC) Express environment.
Cisco recommends that you have knowledge of these topics:
Cisco Customer Response Solutions (CRS)
The information in this document is based on these software and hardware versions:
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
Refer to the Cisco Technical Tips Conventions for more information on document conventions.
The caller does not hear a ring back when the call rings at an agent phone. In the troubled topology, an H.323 voice gateway exists between PSTN and Cisco CallManager, as shown in Figure 1.Figure 1: Topology
If Cisco CallManager receives a PSTN call through the H.323 voice gateway, no ring back tone is played for the routed call. However, the caller can hear a ring back when dialing the agent by the Direct Inward Dial (DID) number.
This is a CallManager configuration issue. Set up a Send H225 User Info Message service parameter for Cisco CallManager Service in CallManager to fix this problem. Complete these steps:
In Cisco CallManager Administration, choose Service > Service Parameter.
Select the correct server from the drop-down list.
Set the service to Cisco CallManager, as shown in Figure 2.Figure 2: Service Parameters Configuration
In the Send H225 User Info Message field, under the Cluster Wide Parameters (Device - H323) section, select H225 Info for Ring Back.Figure 3: Send H225 User Info Message
Reset the H.323 voice gateway.
After you complete these steps, the caller hears ring back when the agent phone rings.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.