This document describes one of the reasons why an agent name change and/or dynamic re-skilling of an agent does not automatically appear in the titlebar or CTIOS Status Screen of the Computer Telephony Integration (CTI) Object Server (OS) Agent Desktop/IP Contact Center (IPCC) Supervisor Desktop in a Cisco Intelligent Contact Management (ICM) Enterprise or Cisco Internet Protocol Contact Center (IPCC) Enterprise environment.
Readers of this document should be knowledgeable of:
Cisco CTIOS Agent Desktop
Cisco IPCC Supervisor Desktop
The information in this document is based on the software and hardware versions:
All Cisco ICM versions prior to 7.0
All Cisco CTIOS versions prior to 7.0
All Cisco CTIOS Agent Desktop versions prior to 7.0
All Cisco IPCC Supervisor Desktop versions prior to 7.0
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, refer to Cisco Technical Tips Conventions.
CTIOS is primarily comprised of two components:
CTIOS server node
CTIOS server connects to the clients and Cisco ICM using TCP connections.
CTIOS uses the same fault-tolerant principles as ICM. In a typical configuration there is a pair of CTIOS (Side A and B), each interfacing with the same pair of ICM and CTI servers. The difference is that both CTIOS are active and working all the time.
CTIOS clients are randomly distributed between the pair to load balance the work. In the event there is a CTIOS failure, the client switches automatically to the other side.
Agent configuration information such as the agent name is passed from a Logger to CTIOS server to CTIOS client.
Changing the name of an existing agent—when you modify the name of an existing agent through ICM Configuration Manager while CTIOS is running, the new modified agent name does not appear in the titlebar of CTIOS Agent Desktop/IPCC Supervisor Desktop. The titlebar still displays the old agent name before the configuration change. The agent name in the titlebar should be appear like the red rectangle in the figure below.
Re-skilling an agent—when you dynamically re-skill an agent from one skillgroup to another on an Admin Workstation (AW) using Agent Explorer, while CTIOS is running, the old skillgroup is still displayed on the agents CTIOS display and on the CTIOS Agent Desktop/IPCC Supervisor Desktop.
When CTIOS starts, it reads all agent information from the ICM configuration database. New agent information, added while CTIOS is running, is transferred from the ICM server to the CTIOS in real time. Therefore, when the new added agent logs in, the correct agent name and skillgroup appears in the titlebar of CTIOS Agent Desktop/IPCC Supervisor Desktop. However, when modifying the name of an existing agent and or dynamically re-skilling the agent, the new name of the existing agent and/or skillgroup change is not transferred to CTIOS from the ICM server until CTIOS service is cycled.
To cycle the CTIOS service, follow the steps below:
Double-click ICM Service Control.
Select the CTIOS service, as shown here.
Click the Stop button to stop CTIOS service.
Click the Start button to start CTIOS service.
After stopping and starting CTIOS, the new name of the existing agent should appear in the titlebar of the CTIOS Agent Desktop.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.