This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. How can I use NSLOOKUP to see my MX records for ProtectLink Gateway Email Protection?A.
To retrieve the MX records using NSLOOKUP, please perform the following:
Open a command prompt.
Type "nslookup" and press Enter. You will see the following:
Default Server: <FQDN of your server>
Address: <server IP address>
Type "set type=mx" and press Enter.
Type the domain name that you want to look up and press Enter. The MX records of that domain will show up.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.