This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Q. How to set up WVC200 with a Cisco Small Business Wireless Router?A.
Connect the Linksys Wireless Camera directly to the Router.
Check the camera LCD for its IP address.
Accessing the Camera's Web-Based Setup Page
Open a web browser such as Internet Explorer.
Go to the Address bar and enter your camera's IP address (e.g."192.168.1.103") then press [Enter].
Under the set up tab you can also configure the wireless settings for your Camera.
Note: Make sure to match the camera's wireless settings to your Linksys Router.
Checking wireless setting on the Router
Type the Router's IP on your Browser.
Accessing the Router's Web based Set up page
A.?Open a web browser such as Internet Explorer.
B.?Go to the Address bar and enter your Router's IP address ("192.168.1.1" is the default IP address of most Linksys routers) then press [Enter}
When the router's web-based setup page appears, click Wireless.
Look for Wireless Network Name (SSID) and if it's still set to "linksys", change it to something unique and take note if Wireless SSID Broadcast is set to Enable.
Unhook the Ethernet cable between the Router and the camera.
Congratulations you're camera is ready to use.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.