Document ID: 109152
Updated: Dec 12, 2008
Contents
Introduction
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products.
Refer to Cisco Technical Tips Conventions for more information on document conventions.
Q. How do I access the setup page for the WVC200?
A. Complete these steps:
- Determine the IP address of the device. By default the device is set to DHCP. The IP address will appear on the LCD panel on front. If there are no DHCP servers available, the camera automatically defaults to 192.168.1.115.
- Open your Internet Explorer and then type the IP address of the device (e.g. http://192.168.1.115). The default username and password for the device is admin. The welcome screen of the Web-based utility appears.
- Click the Setup tab to change the configuration for the device.
- Click the View Video tab to view the camera's video.
Related Information
Open a Support Case 
(Requires a Cisco Service Contract.)
Related Cisco Support Community Discussions
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.
Updated: Dec 12, 2008
Document ID: 109152