Document ID: 108871
Updated: Dec 12, 2008
This article is one in a series to assist in the setup, troubleshooting, and maintenance of Cisco Small Business products (formerly Linksys Business Series).
Q. How can I record motion detection using the Linksys Surveillance Utility on the WVC200?A.
Recording Motion Detection on the WVC200 Using the Linksys Surveillance Utility
If you do not have a valid SMTP server and email account to specify, you may use dummy settings for the email alerts. To modify these settings, follow the steps below:
On the camera's configuration interface, check Enable E-mail Alert and set a Motion Detection Area (adjust the threshold as needed).
Specify Send To and Show From as email addresses. These don't have to be valid email accounts; however, you must follow the syntax firstname.lastname@example.org.
Enter an SMTP Mail Server address.
Note: The mail server doesn't have to be valid, you may use an IP address or a hostname - Authentication doesn't need to be enabled.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.