This document describes how to recover a 7000 (RP) Series Router stuck in ROMmon (rommon # > prompt).
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
The outputs used in this document were tested on the Cisco 7000 router with RP module.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, see the Cisco Technical Tips Conventions.
Follow the instructions provided below:
Issue the dev command to see which devices are available on your router:
>dev Devices in device table: id name flash: internal flash
Issue the dir [device ID] command, and look for a valid Cisco IOS® software image:
>dir flash: File size Checksum File name 4105078 bytes (0x3EA376) 0x9D5F gs7-j-mz.111-30.CA.bin 26545 bytes (0x67B1) 0xD93F crashinfo >
If you find a Cisco IOS software image, try to boot the router using the i command:
>i System Bootstrap, Version 11.1(12), SOFTWARE Copyright (c) 1986-1997 by cisco Systems RP1 processor with 16384 Kbytes of main memory F3: 8552+3996660+165008 at 0x1000 Self decompressing the image : #######################...
If the router still doesn't boot, then the image is corrupted. You need to download a new one using one of the following procedures:
The 7000 with RP has a boot image in ROM. This boot image is actually a full Cisco IOS software image, unlike most other routers. It should always be possible to boot it. If not, consider the possibility of a hardware failure.
See How to Upgrade from ROMmon Using the Boot Image for the detailed instructions.
In the event that you have another similar router, or at least one other router which has a compatible PCMCIA Flash card filesystem (see PCMCIA Filesystem Compatibility Matrix), you can also use that Flash card to recover the router.
If both routers are identical (same series), you can use the Flash card from the other router to boot the one you want to recover. You can then download a valid image the standard way (see Software Installation and Upgrade Procedures). Cisco 7000 routers run their Cisco IOS software from dynamic RAM (DRAM), so you can remove a PCMCIA card while the router is running.
If both routers are different, but have a compatible PCMCIA Flash card filesystem, you can use the other router to load a Cisco IOS software image into a Flash card, which you can then move to the router you are trying to recover.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.