This document provides cable specifications for the WIC-1T one-port WAN interface card.
There are no specific requirements for this document.
This document is not restricted to specific software and hardware versions.
The information in this document was created from the devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If your network is live, make sure that you understand the potential impact of any command.
For more information on document conventions, see the Cisco Technical Tips Conventions.
The WIC-1T features the Cisco 5-in-1 connector which supports several serial protocols (V.35, X.21, RS-232, RS-449, RS-530) when used with the appropriate transition cable. This facilitates easy configuration and re-configuration as network requirements change without the need to purchase a different serial interface card.
Note: When used in Cisco 1720 and 1600 Series Routers, the WIC-1T may also be operated in asynchronous mode. The WIC-1T is not supported in asynchronous mode when used in Cisco 2600 and 3600 Series Routers.
Cisco 5-in-1 (DB-60 pin) cable support includes the following:
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.