This sample configuration shows a Cisco 1417 Digital Subscriber Line (DSL) Router connecting to a Cisco 6130 Digital Subscriber Line Access Multiplexer (DSLAM) and terminating on a Cisco 6400 Universal Access Concentrator (UAC). The Cisco 1417 has been configured with PPP over ATM (PPPoA).
The Internet Service Provider (ISP) has given the subscriber a range of IP addresses, 10.0.0.1 to 10.0.0.X, with a mask of 255.0.0.0. IP address "10.0.0.1" will be manually configured on the Ethernet interface of the Cisco 1417. The subscriber will manually configure the remaining IP addresses on the local LAN devices. Each local device should be configured with a default gateway IP address of 10.0.0.1—the IP address of the Cisco 1417 Ethernet interface.
For more information on document conventions, see the Cisco Technical Tips Conventions.
There are no specific prerequisites for this document.
The information in this document is based on the software versions below.
Cisco 1417 DSL Router IOS® Software Release 12.1(1.3)T
Cisco 6400 UAC-NRP IOS Software Release 12.0(7)DC
Cisco 6400 UAC-NSP IOS Software Release 12.0(4)DB
Cisco 6130 DSLAM-NI2 IOS Software Release 12.1(1)DA
The information presented in this document was created from devices in a specific lab environment. All of the devices used in this document started with a cleared (default) configuration. If you are working in a live network, ensure that you understand the potential impact of any command before using it.
In this section, you are presented with the information to configure the features described in this document.
This document uses the network setup shown in the diagram below.
This document uses the configuration shown below.
Current configuration: ! version 12.1 service timestamps debug datetime msec service timestamps log datetime msec no service password-encryption ! hostname R1 ! ip subnet-zero! interface Ethernet0 ip address 10.0.0.1 255.0.0.0 ! interface ATM0 no ip address atm vc-per-vp 4096 no atm ilmi-keepalive pvc 1/44 encapsulation aal5mux ppp dialer dialer pool-member 1 ! interface Dialer0 ip unnumbered Ethernet0 encapsulation ppp dialer pool 1 dialer-group 1 ppp authentication chap callin ppp chap hostname <username> ppp chap password <password> ! ip classless ip route 0.0.0.0 0.0.0.0 Dialer0 no ip http server ! dialer-list 1 protocol ip permit ! line con 0 end
There is currently no verification procedure available for this configuration.
There is currently no specific troubleshooting information available for this configuration.
The Cisco Support Community is a forum for you to ask and answer questions, share suggestions, and collaborate with your peers.
Refer to Cisco Technical Tips Conventions for information on conventions used in this document.