This chapter describes the Cisco NX-OS commands that begin with A that are used to manage a Cisco Nexus 2000 Series Fabric Extender from a Cisco Nexus 6000 switch.
To access the command-line interface (CLI) of a connected Fabric Extender to run diagnostic commands, use the attach fex command.
Fabric Extender chassis ID. The chassis ID range is from 100 to 199.
This command was introduced.
Use the attach fex command to access the CLI on a connected Fabric Extender and performing diagnostic commands. We recommend that you use this command only following direction from Cisco technical support personnel.
This example shows how to access the CLI of a connected Fabric Extender to run diagnostic commands:
switch# attach fex 101
Displays all configured Fabric Extender chassis connected to the switch.