The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS commands that begin with A that are used to manage a Cisco Nexus 2000 Series Fabric Extender from a Cisco Nexus 6000 switch.
To access the command-line interface (CLI) of a connected Fabric Extender to run diagnostic commands, use the attach fex command.
attach fex chassis_ID
chassis_ID |
Fabric Extender chassis ID. The chassis ID range is from 100 to 199. |
None
EXEC mode
|
|
6.0(2)N1(1) |
This command was introduced. |
Use the attach fex command to access the CLI on a connected Fabric Extender and performing diagnostic commands. We recommend that you use this command only following direction from Cisco technical support personnel.
This example shows how to access the CLI of a connected Fabric Extender to run diagnostic commands:
switch#
attach fex 101
|
|
---|---|
show fex |
Displays all configured Fabric Extender chassis connected to the switch. |