Table Of Contents

WAVE-7541, WAVE-7571, and WAVE-8541 Hardware Specifications

Appliance Specifications

Interface Module Specifications

WAVE-7541, WAVE-7571, and WAVE-8541 Hardware Specifications

---

This appendix provides hardware specifications for the WAVE-7541, WAVE-7571, and WAVE-8541 appliance. It contains the following sections:

•Appliance Specifications

•Interface Module Specifications

Appliance Specifications

Table A-1 provides a summary of the features and specifications of the WAVE-7541, WAVE-7571, and WAVE-8541.

Table A-1 WAVE-7541, WAVE-7571, and WAVE-8541 Features and Specifications 

Specification	Description
Microprocessor	•2 Intel Xeon Quad-Core Processors E5620, or 2 Intel Xeon Hex-Core Processors E5645 •2.4 GHz •12 MB cache
Memory	•24 GB to 96 GB ECC DDR3 SDRAM (RDIMM) 1066/1333 MT/s
Mass storage	•RAID-5 array with six 450-GB SAS hard disk drives, or RAID-5 array with eight 450-GB SAS hard disk drives, or RAID-5 array with eight 600-GB SAS hard disk drives WAVE-8541 •RAID-5 array with eight 600-GB SAS solid state drives
Fans	•9 externally accessible, hot-plug fans
Expansion slots	•1 Interface Module Slot for Cisco Interface Modules
Size	•Height: 87 mm (3.42 in) •Depth: 632 mm (24.88 in); includes power supply handles •Width: 429 mm (16.89 in)
Weight	Maximum Weight (no carton): 21.62 kg (47.66 lb) (Includes the weight of one Cisco Interface Module, two power supplies, and eight hard disk drives.)
Electrical Input Requirements1	•Range Line Voltage: 90 to 132 VAC, 180 to 264 VAC •Maximum Rated Input Current: 10 A - 5 A (100 to 240VAC) •Rated Input Frequency: 47 to 63 Hz •Maximum Real Input Power: 730W total (shared load when redundant)
BTU Rating	2491 BTU/hr Maximum
Power supply output	•Rated steady-state power: 650 W (across input of 100 - 240 VAC) •Efficiency: Minimum of 89% at 100% electrical load
Acoustic noise2	•Idle: 45.8 dBA •Operating (70% load): 46.1 dBA
Environment	•Air temperature: –Operating3 : 0 to 40 ºC (32 to 104 ºF) –Non-operating: -30 to 60 °C (-22 to 140 °F) •Humidity: –Operating: 10% to 90% RH (non-condensing) –Nonoperating: 5% to 95% RH (non-condensing) •Altitude: –Operating: 3,050 m (10,000 ft) –Nonoperating: 4572 m (15,000 ft)

1 Electrical input specifications apply at 23 ºC (73.4 ºF). 2 Levels are A-weighted sound pressures measured in a 23 ºC (73.4 ºF) ambient environment. Measurements were made per ISO 7779 (ECMA 74; ANSI S12.10) methods and are declared per ISO 9296 (ECMA 109). 3 All temperature ratings shown are for sea level to 1,000 meters (3,281 ft) with de-rating of maximum temperature for increase in altitude. If operating location is above 1,000 meters (3,281 feet), deduct 3 ºC (5.4 ºF) from the maximum operating temperature for each additional 1,000 meters (3,281 ft).

Interface Module Specifications

Table A-2 describes the Interface Module technical and general specifications.

Table A-2 Inline Network Adapter Specifications 

Specification	Description
Copper Gigabit Ethernet Bypass (4-port and 8-port)
IEEE standard	Gigabit Ethernet, 1000BASE-T, IEEE 802.3-2000 Fast Ethernet, 100BASE-T, IEEE 802.3-2000 Ethernet, 10BASE-T, IEEE 802.3-2000
Duplex	Supports both half-duplex and full-duplex operation in all operating speeds
Autonegotiation	Autonegotiates between full-duplex and half-duplex operations and between 1000 Mbps, 100 Mbps, and 10 Mbps speeds
Data transfer rate	1000 Mbps, 100 Mbps, and 10 Mbps speeds per port in half-duplex mode 2000 Mbps, 200 Mbps, and 20 Mbps speeds per port in full-duplex mode
Ports	4-Port Interface Module: 4 × RJ-45 socket connectors 8-Port Interface Module: 8 × RJ-45 socket connectors
Fiber Optic Gigabit Ethernet Bypass (4-port)
IEEE standard	Gigabit Ethernet, 1000BASE-SX, IEEE 802.3-2000
Duplex	Supports full-duplex only
Optical reach	137 m (449 ft) to any individual port to account for 274 m (899 ft) total when operating in bypass mode
Data transfer rate	2000 Mbps in full-duplex
Ports	4 Fixed LC Duplex Connectors
SFP+ 10 Gigabit Ethernet (2-port)
IEEE standard	The Cisco 10 Gigabit Ethernet Interface Module for WAAS only supports Cisco pluggable optical transceiver modules. Consult the following data sheet URL for supported modules: Cisco 10GBASE SFP+ Modules
Duplex	Supports full-duplex only
Autonegotiation	Autonegotiates pluggable transceiver type 1 Gbps or 10 Gbps
Data transfer rate	2000 Mbps and 20000 Mbps
Ports	2 Pluggable SFP/SFP+ sockets
Optical reach	Varies per module type. Consult the following data sheet URL for supported modules: Cisco 10GBASE SFP+ Modules
General Technical Specifications
Dimensions	38 mm (1.5 in) H x 121 mm (4.75 in) W x 264 mm (10.38 in) D
Weight	0.73 kg to 0.91 kg (1.61 lb to 2.01 lb)
Operating humidity	10 to 90% RH (non-condensing)
Operating temperature	0 to 40 ºC (32 to 104 ºF
Operating altitude	3,050 m (10,000 ft)
Non-operating temperature	-30 to 60 ºC (-22 to 140 ºC)
Non-operating humidity	5 to 95% RH (non-condensing)
Non-operating altitude	4,572 m (15,000 ft)