Table Of Contents

Wide Area Application Engine Hardware Specifications

Appliance Specifications

Adapter Specifications

Wide Area Application Engine Hardware Specifications

---

This appendix provides hardware specifications for the WAE-7371, WAE-7341, and WAE-674 appliances and the optional Cisco WAE inline network adapter. It contains the following sections:

•Appliance Specifications

•Adapter Specifications

Appliance Specifications

Table A-1 provides a summary of the features and specifications of the Wide Area Application Engine (WAE) 7371, 7341, and 674.

Table A-1 WAE 7371, 7341, and 674 Features and Specifications 

Specification	Description
Microprocessor	•WAE-7371: 2 Xeon quad-core processors, 2.33 GHz •WAE-7341: 1 Xeon quad-core processor, 2.33 GHz •WAE-674: 1 Xeon quad-core processor, 2.00 GHz •8 MB Level 2 cache •1333-MHz front-side bus (FSB) Note Use the Configuration/Setup utility program to determine the type and speed of the microprocessors.
Memory	•WAE-7371: 24 GB •WAE-7341: 12 GB •WAE-674: 4 GB (optionally 8 GB)
Drives standard	•DVD-ROM/CD-RW combination drive •WAE-7371: RAID-5 array with six 300-GB SAS hard disk drives •WAE-7341: RAID-5 array with four 300-GB SAS hard disk drives •WAE-674: RAID-5 array with three 300-GB SAS hard disk drives
Expansion bays	•6 hot-swap, 3.5-inch hard disk drive bays •1 5.25-inch (13.34-cm) bay (DVD-ROM/CD-RW combination drive installed)
Fans	•WAE-7371 and WAE-7341: 10 fans •WAE-674: 5 fans (optionally 10 fans)
Hot-swap Power supplies	•WAE-7371 and WAE-7341: 2 hot-swap, 835 W, 100-240 VAC •WAE-674: 1 hot-swap, 835 W, 100-240 VAC (optionally 2 power supplies)
Expansion slots	•2 PCI-X non-hot-pluggable 133-MHz/64-bit (one full length and one half length) •2 PCI-Express non-hot-pluggable (low profile)
Size	•Height: 3.36 in. (85.4 mm) •Depth: 27.8 in. (705.0 mm) •Width: 17.5 in. (443.6 mm)
Weight	46.5 lb (21.09 kg) to 64 lb (29.03 kg) depending upon configuration
Integrated functions	•Baseboard management controller •2 Broadcom 10/100/1000 Ethernet controllers (dual-port design) with Wake on LAN support •1 serial port •1 RAID controller •1 serial attached SCSI (SAS) controller Note The baseboard management controller is also known as the service processor.
Electrical Input	•Sine wave input (50-60 Hz) required •Input voltage range automatically selected •Input voltage low range: –Minimum: 100 VAC –Maximum: 127 VAC •Input voltage high range: –Minimum: 200 VAC –Maximum: 240 VAC •Input kilovolt-amperes (kVA) approximately: –Minimum: 0.29 kVA –Maximum: 1.0 kVA
Environment	•Air temperature: –Device on: 50 to 95×F (10 to 35×C); altitude: 0 to 914.4 m (3000 ft) –Device off: 50 to 109.4×F (10 to 43×C); maximum altitude: 2133 m (7000 ft) •Humidity –Device on: 8 to 80% –Device off: 8 to 80%
1 Acoustical noise emissions	•Declared sound power, idle: 6.8 bel2 •Declared sound power, operating: 6.8 bel
3 Heat Output	•Minimum configuration: 1230 Btu4 (360 watts) •Maximum configuration: 3390 Btu (835 watts)

1 These levels were measured in controlled acoustical environments according to the procedures specified by the American National Standards Institute (ANSI) S12.10 and ISO 7779 and are reported in accordance with ISO 9296. Actual sound-pressure levels in a given location might exceed the average values stated because of room reflections and other nearby noise sources. The declared sound-power levels indicate an upper limit, below which a large number of computers will operate. 2 In acoustics, the logarithm of the ratio of a quantity to a reference quantity of the same kind is called a level. The base of the logarithm (always ten, unless otherwise specified), the reference quantity, and the kind of level shall be specified. bel is a unit of level when the base of the logarithm is ten, and the quantities concerned are proportional to power. 3 Power consumption and heat output vary depending on the number and type of optional features installed and the power-management optional features in use. 4 BTU = British Thermal Unit.

Adapter Specifications

Table A-2 describes the inline network adapter technical and general specifications.

Table A-2 Inline Network Adapter Specifications 

Specification	Description
Copper Gigabit Ethernet Specifications
IEEE standard	•Gigabit Ethernet, 1000BASE-T •Fast Ethernet, 100BASE-T •Ethernet, 10BASE-T
Full duplex and half duplex	Supports both half-duplex and full-duplex operation in all operating speeds
Autonegotiation	Autonegotiates between full-duplex and half-duplex operations and between 1000-Mbps, 100-Mbps, and 10-Mbps speeds
Data transfer rate	•1000-Mbps, 100-Mbps, and 10-Mbps speeds per port in half-duplex mode •2000-Mbps, 200-Mbps, and 20-Mbps speeds per port in full-duplex mode
General Technical Specifications
Interface standard	•PCI v2.2 32/64 bit, 33/66 MHz •PCI-X v1.0 32/64 bit, 66/100/133 MHz
Size	6.6 x 4.2 in. (167.64 x 106.68 mm)
PCI connector	Universal 64-bit connector
PCI voltage	•+12 V (minimum 11.4 V, maximum 12.6 V) •+3.3 V (minimum 3.0 V, maximum 3.6 V)
Weight	6.18 oz (175 g)
Operating humidity	0 to 90%, noncondensing
Operating temperature	32 to -122oF (0 to 50oC)
Storage temperature	-4 to -149oF (-20 to -65oC)