Cisco Nexus 7000 Series NX-OS MPLS Command Reference
G Commands
Downloads: This chapterpdf (PDF - 108.0KB) The complete bookPDF (PDF - 5.67MB) | Feedback

G Commands

Table Of Contents

G Commands

graceful-restart


G Commands


This chapter describes the Cisco NX-OS Multiprotocol Label Switching commands that begin with G.

graceful-restart

To configure the graceful restart timer, use the graceful-restart command. To return to the default setting, use the no form of this command.

graceful-restart [timers {forwarding-holding seconds | max-recovery seconds | neighbor-liveness seconds}]

no graceful-restart [timers {forwarding-holding seconds | max-recovery seconds | neighbor-liveness seconds}]

Syntax Description

timers

(Optional) Specifies VPN routing.

forwarding-holding seconds

Specifies the forwarding state holding time. The range is from 30 to 600 seconds.

max-recovery seconds

Specifies the maximum recovery time. The range is from 15 to 600 seconds.

neighbor-liveness seconds

Specifies the neighbor lifetime. The range is from 5 to 300 seconds.


Defaults

Enable

Command Modes

LDP configuration mode

Supported User Roles

network-admin
vdc-admin

Command History

Release
Modification

5.2(1)

This command was introduced.


Usage Guidelines

You must configure the MPLS VPN and VRFs before creating VRF-aware static labels.

This command requires the MPLS Services license.

Examples

This example shows how to configure the graceful restart timer:

switch(config-ldp)# configure terminal
switch(config)# mpls ldp configuration
switch(config-ldp)# graceful-restart timers forwarding-holding 30
switch(config-ldp)#
 
   
 
   

Related Commands

Command
Description

mpls ldp configuration

Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP).