The documentation set for this product strives to use bias-free language. For the purposes of this documentation set, bias-free is defined as language that does not imply discrimination based on age, disability, gender, racial identity, ethnic identity, sexual orientation, socioeconomic status, and intersectionality. Exceptions may be present in the documentation due to language that is hardcoded in the user interfaces of the product software, language used based on RFP documentation, or language that is used by a referenced third-party product. Learn more about how Cisco is using Inclusive Language.
This chapter describes the Cisco NX-OS Multiprotocol Label Switching commands that begin with V.
To configure a virtual private network (VPN) ID on a Virtual Forwarding Interface (VFI) context, use the vpn command.
|
|
---|---|
This example shows how to configure a VPN ID on a VFI context:
|
|
---|---|
Enters bridge-domain configuration mode and configures a bridge domain. |
|
Establishes a Layer 2 VPN (L2VPN) virtual forwarding interface (VFI) between two or more separate networks. |
To display information for a virtual routing and forwarding (VRF) instance, use the vrf command. To return to the default setting, use the no form of this command.
VRF name that is any case-sensitive alphanumeric string up to 32 characters. |
|
|
---|---|
This example shows how to display information about each VRF instance:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |
To create a new virtual routing and forwarding (VRF) instance, use the vrf context command. To return to the default setting, use the no form of this command.
VRF name that can be any case-sensitive, alphanumeric string up to 20 characters. |
|
|
---|---|
This example shows how to create a new VRF instance:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |
To set virtual routing and forwarding (VRF) membership on an interface, use the vrf member command. To return to the default setting, use the no form of this command.
|
|
---|---|
This example shows how to set VRF membership for an interface:
|
|
---|---|
Configures the Multiprotocol Label Switching (MPLS) Label Distribution Protocol (LDP). |